Experimental and Numerical Study of the Laminar Burning Velocity and Pollutant Emissions of the Mixture Gas of Methane and Carbon Dioxide
Yalin Wang,Yu Wang,Xueqian Zhang,Guoping Zhou,Beibei Yan,Rob J. M. Bastiaans
DOI: https://doi.org/10.3390/ijerph19042078
IF: 4.614
2022-02-12
International Journal of Environmental Research and Public Health
Abstract:This paper presents the experimental and numerical study of the laminar burning velocity and pollutant emissions of the mixture gas of methane and carbon dioxide. Compared to previous research, a wider range of experimental conditions was realized in this paper: CO2 dilution level up to 60% (volume fraction) and equivalence ratio of 0.7–1.3. The burning velocities were measured using the heat flux method. The CO and NO emissions after premixed combustion were measured by a gas analyzer placed 20 cm downstream of the flame. The one-dimensional free flames were simulated using the in-house laminar flame code CHEM1D. Four chemical kinetic mechanisms, GRI-Mech 3.0, San Diego, Konnov, and USC Mech II were used in Chem1D. The results showed that, for laminar burning velocity, the simulation results are all lower than the experimental results. GRI Mech 3.0 showed the best agreement when the CO2 content was below 20%. USC Mech II showed the best consistency when the CO2 content was between 40 and 60%. For CO emission, these four mechanisms all showed a small error compared with the experiments. When CO2 content is higher than 40%, the deviation between simulation and experiment becomes bigger. When the CO2 ratio is more than 20%, the proportion of CO2 does not affect CO emission so much. For NO emission, when the CO2 content is 40%, the results from simulation and experiment showed a good agreement. As the proportion of CO2 increases, the difference in NO emissions decreases.
public, environmental & occupational health,environmental sciences