Abstract:Rotating cavities with axial throughflow are found inside the compressor rotors of turbo-machines. The flow pattern and heat transfer in the cavities are known as sophisticated problems. Because of the numerical errors and model errors, as well as the stiffness introduced by low-Ma number, prediction of 3D unsteady flow and heat transfer in rotating cavity is still a challenge for modern CFD technology. An in-house 3D unsteady CFD code was developed in this study. The discontinuous galerkin method, which can fulfill any high-order accuracy on the unstructured grid, was applied to reduce the discretization errors. The SST-γ-Reθ transition model proposed by Menter was applied to reduce the model errors. To overcome the stiffness and achieve good convergence characteristics and solution quality, the preconditioning matrix technique combined with DG method was introduced for low-Ma number viscous flow. First, natural convection of air in a square cavity was studied to test the code. The feasibility and credibility, of applying the DG method and the preconditioned matrix technique for buoyancy–induced Rayleigh-Bénard like flow, were further verified. Second, the 3D compressible flow field in a rotating cavity was investigated numerically using the FV method, DG method and laminar/SA/SST-transition turbulence model. It is demonstrated that the whole flow structure of all calculated cases was similar after comparing the calculated results with the available experimental data. But, the transition turbulence model fitted the experimental data better. On the other hand, the performance of high-order method was much better for both the rotating cavity flow and natural convection, in terms of heat transfer. To better understand this phenomenon, an accuracy analysis of heat flux using DG method and FV method was performed. It showed the DG method could realize arbitrary precision of viscous stress and heat fluxes on irregular unstructured grids, while the FV method could only realize the first-order accuracy of the heat fluxes at the boundary faces and may exhibit erroneous behaviors. It also demonstrated that the high-order accuracy of gradients was needed to decrease errors of heat fluxes and viscous stresses, and that DG method was a promising method.

Numerical Simulation for Transient Flow in a Rotary Compressor Using Dynamic Mesh Technique

Numerical Simulation of Rotating Stall Inside High Speed Centrifugal Compressor Using Entire Geometry Mesh

Numerical Simulation of Thermal and Fluid-Dynamic Behaviour of Reciprocating Compressor

Simulation of Dynamic Characteristics of Moving Magnet Linear Compressor for Refrigerator

Numerical Simulation for Flow of Rolling Piston Type of Rotary Compressor

Summary of Numerical Simulation of the Internal Flow in the Turbomachinery

Numerical Simulation and Optimization of Internal Flow Field in the High Pressure Coal Conveying Pump Based on the Dynamic Mesh

CFD Simulation of a Rotary Compressor with Gas Injection

Simulation on two-phase refrigerant compression in the cylinder of rotary compressors using CFD method

Air Flow Analysis of a Rotating Cylinder through Numerical Simulation

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Coupled Fluid-Thermal-Solid Simulation of Axial Through-Flow Rotating Cavities

CFD Simulation for the Internal Pressure Characteristics of an Oil-Injected Twin-Screw Refrigeration Compressor

THREE-DIMENSION NUMERICAL SIMULATION OF DISCHARGE FLOW IN A SCROLL AIR COMPRESSOR

Dynamic Model and Numerical Simulation for Synchronal Rotary Compressor

The Numerical Simulation on Fluid Property of Inlet Volute in an Axial Flow Compressor Based on CFD

Numerical Investigation of the Unsteady Flow in a Transonic Compressor with Curved Rotors

Application of the Rotating Modification k-ε Turbulence Model to Three-dimensional Flow Simulation in a Rotary Combustion Engine

Numerical simulation of the flow and temperature field of ventilated rotor for special asynchronous generators

Equation-based Performance Simulation for Centrifugal Compressor

Prediction of 3d Unsteady Flow and Heat Transfer in Rotating Cavity by Discontinuous Galerkin Method and Transition Model