Abstract:CdS nano material which has a band gap of 2.42 eV at room temperature is a typical II-VII semiconductor having many commercial or potential applications, e.g., light-emitting diodes, solar cell and optoelectronic devices. In this paper, we use a new strategy to synthesize CdS nanorods. CdS nanorods were prepared in soft template under gamma-irradiation though the reaction of cadmium sulphide and thiacetamide (TAA). The formation process and characters of CdS nanorods was investigated in detail by transmission electron microscopy (TEM), electron diffraction (ED) pattern, X-ray powder diffraction (XRD), ultraviolet spectrophotometer (UV) and photoluminescence spectrophotometer (PL). In the experiment we proposed that the irradiation of gamma-ray accelerated the formation of S(2-) under acidic condition (pH = 3) and vinyl acetate (VAc) monomer formed pre-organized nano polymer tubules which were used as both templates and nanoreacters for the growth of CdS nanorods. In this process, we have obtained the CdS polycrystal nanorods with PVAc nano tubules and CdS single-crystal nanorods. The result of X-ray powder diffraction confirms that the crystal type of CdS nanorods is cubic F-43 m (216). The results from transmission electron microscopy and electron diffraction show that the concentrations of reactants and the dose rate of gamma-ray are key to produce appropriate CdS nanorods. Relatively low concentrations (Cd2+: 0.008-0.02 mol/L, Cd2+ : S(2-) = 1 : 2) of reactants and long time (1-2 d) of irradiation in low dose rate (6-14 Gy/min) are propitious to form CdS single-crystal nanorods with small diameter (less than 100 nm) and well length (2-5 microm). UV and PL characterizations show the sample have well optical properties.

A rapid synthesis route for the preparation of CdS nanoribbons by microwave irradiation

Preparation of CdS nanowires by the decomposition of the complex in the presence of microwave irradiation

A Facile Single-Source Route to CdS Nanorods.

Single crystalline CdS nanorods fabricated by a novel hydrothermal method

Preparation and Growth Mechanism of CdS Nanorods via Chemical Bath Deposition

Synthesis of Single Crystalline CdS Nanorods by a PVP-assisted Solvothermal Method

Synthesis, Characterization and Optical Properties of CdS Nanorods by a Simple Solution Chemistry Method

Microwave-Assisted Solvothermal Synthesis of Radial ZnS Nanoribbons

Synthesis and Characterization of CdS Nanorods Via Hydrothermal Microemulsion

Preparation of CdS and ZnS nanoparticles using microwave irradiation

Controllable Synthesis of Corrugated CdS Nanoribbons of High Quality by Vapor–liquid–solid Method

Fabrication of CdS Nanorods in Inverse Microemulsion Using HEC As a Template by a Convenient Γ-Irradiation Technique

Solvothermal Synthesis and Characterization of Uniform CdS Nanowires in High Yield

Synthesis of CdS Nanorods in Soft Template under Γ-Irradiation

Synthesis of CdS nanoparticles in water/DMF medium: an investigation on the effect of time and microwave irradiation

A microwave assisted heating method for the preparation of copper sulfide nanorods

A novel ultraviolet-irradiation route to CdS nanocrystallites with different morphologies

"Scission-template-transportation" route to controllably synthesize CdIn2S4 nanorods

Trioctylphosphine As Both Solvent and Stabilizer to Synthesize CdS Nanorods

Preparation of Cu2S Nanoribbons from Cu(thiocarbamide)Cl·1/2H2O Complex Nanowires by Solid-state Reaction at Room Temperature Without Surfactants

Synthesis of Brush-Like CdS Nanorod Arrays Through a Novel Hydrothermal Reaction of Simultaneous Solvent-Oxidation-hydrolysis