Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Dissolution Characteristics of Carbide Slag During Wet Flue Gas Desulfurization

D215 DISSOLUTION CHARACTERISTICS OF CARBIDE SLAG, FLY ASH AND LIMESTONE : EXPERIMENT AND MODELLING(Environmental Protection-3)

Desulfurization Characteristics of Carbide Slag during Circulating Fluidized Bed Coal Combustion

Dissolution Mechanism of Modifying Agent in Fibrotic Process of Steel Slag

Dissolution Rate Of Limestone For Wet Flue Gas Desulfurization In The Presence Of Sulfite

Dissolution of Carbon-Containing Species in CaO-SiO 2 -Al 2 O 3 Slag

High-temperature Desulfurization of Carbide Slag and Bauxite During Coal Combustion

High efficiency desulfurization behavior by the sustainable low carbon utilization of carbide slag

Application and Research of High Molecular Carboxylates in Desulphurization System of Thermal Power Plant

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Experimental Study on Combustion Desulfurization of Sludge Coal Water Slurry

Preparation of Sulfur Dioxide by Divalent Iron Synergistic Coke Reduction of Phosphogypsum in a Fluidized Bed

Using carbide slag as desulfurater in dry flue gas desulfurization system

Effect of Particle Size in a Limestone-Hydrochloric Acid Reaction System.

Calcination Condition of Dolomite‐Based Materials Influencing Static Dissolution in Synthetic Electric Arc Furnace Slag

Contrastive study on the removal of sulfide from carbide slag slurry for desulfurization

Dissolution kinetics of P-bearing steelmaking slag in the citric acid solution

Feasibility Study of Using Carbide Slag as In-Bed Desulfurizer in Circulating Fluidized Bed Boiler

Influence of Fe 2 O 3 and Atmosphere on Crystallization Characteristics of Synthetic Coal Slags

Dissolution Behavior Of Sio2 In The Molten Blast Furnace Slags

Experimental study of hot gas desulphurization with limestone sorbent