Abstract:To begin with, the micro‐bare‐tube heat transfer coefficients were simulated under genetic algorithms. Also, the best micro‐bare‐tube operation parameters and geometric parameters were determined by the new model prediction. This study presents the optimization of the heat transfer coefficient of a micro bare tube heat exchanger. A physical and mathematical model of a micro bare tube heat exchanger was built in Matlab using the simplified ε‐number of transfer unit method. Using a temperature of minus 30°C and a 0.5–1.0 mm tube outer diameter, a 1.7–8.0 mm longitudinal tube pitch, a 1.7–5 mm transverse tube pitch, and a 1.0–5.0 m/s velocity at minimum free flow area, with carbon dioxide as the refrigerant, a comparative variation analysis was performed to optimize the heat transfer coefficient of a micro‐bare‐tube heat exchanger. The results demonstrate that the heat transfer coefficient increases as the inlet air velocity is increased from 1.0 to 5.0 m/s, with a final gain of 93.17%. The growth rate of the heat transfer coefficient steadily decreases with increasing inlet air velocity and gradually approaches zero. The effect of the gradual decrease of the tube outer diameter from 1.0 to 0.5 mm on the heat transfer coefficient is 22.52% greater than that of the gradual decrease of the transverse tube pitch from 2.2 to 1.7 mm. The study also carried out an optimization analysis on the distribution of four different variables in the heat exchanger. With the use of a genetic algorithm, the study found an optimal distribution to maximize the heat transfer coefficient. The following parameter values resulted in the maximum heat transfer coefficient: a maximum inlet air velocity of 5.0 m/s, a minimum tube outer diameter of 0.5 mm, a 1.7 mm longitudinal tube pitch, and a 1.7 mm transverse tube pitch.

Optimized design of self-pressured vaporizer based on genetic algorithm

Energy Saving Strategy Development In Liquid Desiccant Dehumidifier By Genetic Algorithm

A New DNA Genetic Algorithm and Its Application in Parameter Estimation

Research on the Methods of Optimal Design of Taper Roller Bearing Based on Improved Genetic Algorithm

High-efficiency design of combustion kinetic experiments based on genetic algorithm

Model-based optimization strategy of chiller driven liquid desiccant dehumidifier with genetic algorithm

Optimal design of convection heating surface of boiler based on genetic algorithm

Intelligent optimization design of shell and helically coiled tube heat exchanger based on genetic algorithm

Optimal Design of Pressure Vessel Using an Improved Genetic Algorithm

Optimization of heat transfer performance of a micro‐bare‐tube heat exchanger using a genetic algorithm

Multi-Objective Optimization of Parallel-Connected Double-Effect Mechanical Vapor Recompression System Based on Genetic Algorithm

Optimization Design of Tube-Shell Heat Exchanger Based on Genetic Algorithm

Optimal design for a copper vapor laser with a maximum output by using a genetic algorithm

Experimental and Numerical Optimization Study on an Airfoil-Shaped Heat Exchanger

MODELING AND OPTIMAL DESIGN FOR MICRO-THERMOELECTRIC GENERATOR

Optimization for a steam turbine stage efficiency using a genetic algorithm

Optimizing the size of a printed circuit heat exchanger by multi-objective genetic algorithm

The Micro Genetic Algorithm and Its Usage in the Optimization Design of Mixed-Flow Pump

Multi-objective optimization of a double helical coil heat exchanger using response surface method and genetic algorithm

Multi-Objective Finned-Tube Heat Exchanger Optimization Using a Genetic Algorithm

Optimization of Flow Behavior Models by Genetic Algorithm: A Case Study of Aluminum Alloy