Structure modeling and simulation of new type of tamping device

LIU Yi,GONG Guo-fang,ChaoQing Min,LIU Guo-bin

DOI: https://doi.org/10.3785/j.issn.1008-973X. 2011.11.009

2011-01-01

Abstract:Combined with analyzing the excitation principle and structure characteristics of tamping unit produced by three companies Plasser,Matisa and Harsco,a new tamping device with hydraulic excitation and independent clamping movement was proposed to overcome the strong swing problem of the clamping cylinder generated by tamping bar vibration.A new type of rotary valve is also designed to improve the control of oscillating tamping cylinder.Simulation analysis was carried out by using Matlab/Simulink in terms of the mathematic model established.The results show that the maximum displacement of the oscillating cylinder is 4.2 mm when the spool frequency and the axial area guide width of valve port as well as the maximum radial guided width of the spool groove are set to 10 Hz,10 mm and 8 mm respectively,thus back and forth vibration with the tamping bar amplitude 8.82 mm and frequency of cylinder 40 Hz can be achieved.The area of the valve port and the displacement of the oscillating cylinder are determined by the axial area guide width of valve port.When the oscillating frequency is bigger,the displacement of the oscillating cylinder and the period of motion are smaller.