Abstract:This paper introduces a model to estimate average link travel time of signalized arterials using data obtained from stop-line detectors. The proposed model makes use of detectors at the upstream stop line of a link to capture the arrival of vehicles into the link at short intervals of 2 seconds, and a platoon dispersion sub-model to project the vehicle arrival times at the downstream stop line. Using the vehicle departure patterns obtained at detectors at the downstream stop line, the average link travel time is then calculated. The sensitivity of the estimated link travel time with Tracz, Pacey and Robertson platoon dispersion sub-models have been tested by means of microscopic traffic simulations. The results show that the accuracy of the link travel time is not sensitive to the different platoon dispersion sub-models. However, the Tracz sub-model was recommended for its smallest errors. The accuracy of the proposed model, with the calibrated Tracz platoon dispersion sub-model, has also been tested for link lengths between 300 m to 800 in, under different urban street level of service defined in the U.S. Highway Capacity Manual. Results indicate that the proposed link travel time estimation model has an average absolute error of 2.26 seconds, which is lower than the estimation errors given by the existing British, Illinois and Iowa arterial link travel time estimation models. Tests on the sensitivity of the coefficient of the Tracz platoon dispersion sub-model had also been carried out. It was found that the value of the Tracz platoon dispersion coefficient has minimal effect on the accuracy of the estimated average link travel time. The results of this paper has indicated that, with some modifications in the intersection signal controller's card to capture the arrival time and departure times of vehicles at interval of 2 seconds, it is possible to make use of existing stop-line detectors to collect detailed vehicle actuation data for link travel time estimation with reasonably good accuracy.

Variability of Travel Time Estimates using Probe Vehicle Data

Freeway Travel-Time Estimation Based on Temporal–Spatial Queueing Model

Study of Probe Vehicle Technology

Measuring Variability of Arterial Road Traffic Condition Using Archived Probe Data

Link Travel Time Estimation Based on Vehicle Infrastructure Integration Probe Data

Travel Time Estimation Method for Urban Road Based on Traffic Stream Directions

Exploring Travel Time Distribution and Variability Patterns Using Probe Vehicle Data: Case Study in Beijing

Probe Vehicle Population and Sample Size for Arterial Speed Estimation

Analysis of Time- and Space-domain Sampling for Probe Vehicle-based Traffic Information System.

On the Distribution of Probe Traffic Volume Estimated without Trajectory Reconstruction

Real-time Estimation of Vehicle Counts on Signalized Intersection Approaches Using Probe Vehicle Data

Copula-Based Travel Time Distribution Estimation Considering Channelization Section Spillover.

Development of a Machine-Learning-Based Novel Framework for Travel Time Distribution Determination Using Probe Vehicle Data

Empirical Study of Travel Time Estimation and Reliability

Modelling and Estimation of Travel Time Variability

A Real-time Traffic Information System Using Probe Vehicles

ESTIMATION OF ARTERIAL TRAVEL TIME USING STOP-LINE DETECTORS WITH PLATOON DISPERSION MODELS

Arriving on time: estimating travel time distributions on large-scale road networks

A cross-vendor and cross-state analysis of the GPS-probe data latency

Developing travel time estimation methods using sparse GPS data

Estimation of Queue Lengths, Probe Vehicle Penetration Rates, and Traffic Volumes at Signalized Intersections using Probe Vehicle Trajectories