Abstract:This paper introduces a model to estimate average link travel time of signalized arterials using data obtained from stop-line detectors. The proposed model makes use of detectors at the upstream stop line of a link to capture the arrival of vehicles into the link at short intervals of 2 seconds, and a platoon dispersion sub-model to project the vehicle arrival times at the downstream stop line. Using the vehicle departure patterns obtained at detectors at the downstream stop line, the average link travel time is then calculated. The sensitivity of the estimated link travel time with Tracz, Pacey and Robertson platoon dispersion sub-models have been tested by means of microscopic traffic simulations. The results show that the accuracy of the link travel time is not sensitive to the different platoon dispersion sub-models. However, the Tracz sub-model was recommended for its smallest errors. The accuracy of the proposed model, with the calibrated Tracz platoon dispersion sub-model, has also been tested for link lengths between 300 m to 800 in, under different urban street level of service defined in the U.S. Highway Capacity Manual. Results indicate that the proposed link travel time estimation model has an average absolute error of 2.26 seconds, which is lower than the estimation errors given by the existing British, Illinois and Iowa arterial link travel time estimation models. Tests on the sensitivity of the coefficient of the Tracz platoon dispersion sub-model had also been carried out. It was found that the value of the Tracz platoon dispersion coefficient has minimal effect on the accuracy of the estimated average link travel time. The results of this paper has indicated that, with some modifications in the intersection signal controller's card to capture the arrival time and departure times of vehicles at interval of 2 seconds, it is possible to make use of existing stop-line detectors to collect detailed vehicle actuation data for link travel time estimation with reasonably good accuracy.

Link Travel Time Estimation Based on Vehicle Infrastructure Integration Probe Data

Freeway Travel-Time Estimation Based on Temporal–Spatial Queueing Model

Arterial Travel Time Estimation Using VII Probe Data and Point-Based Detection Data

Travel Time Estimation Method for Urban Road Based on Traffic Stream Directions

Traffic State and Emission Estimation for Urban Expressways Based on Heterogeneous Data

An Extended Generalized Filter Algorithm for Urban Expressway Traffic Time Estimation Based on Heterogeneous Data

Real-Time Estimation of Vehicle-Count Within Signalized Links

ESTIMATION OF ARTERIAL TRAVEL TIME USING STOP-LINE DETECTORS WITH PLATOON DISPERSION MODELS

Grouped Travel Time Estimation in Signalized Arterials Using Point-to-point Detectors

Real-time Estimation of Vehicle Counts on Signalized Intersection Approaches Using Probe Vehicle Data

An Improved Method For Estimating Urban Traffic State Via Probe Vehicle Tracking

Travel Time Estimation for Urban Arterials Based on the Multi-Source Data

Copula-Based Travel Time Distribution Estimation Considering Channelization Section Spillover.

Study of Probe Vehicle Technology

Estimation of urban traffic state with probe vehicles

Estimation of Queue Lengths, Probe Vehicle Penetration Rates, and Traffic Volumes at Signalized Intersections using Probe Vehicle Trajectories

Evaluating the Performance of Link Travel Time Estimation Based on Floating Car Data

Traffic Demand Estimation for Lane Groups at Signal-Controlled Intersections Using Travel Times from Video-Imaging Detectors

Fitting Travel Time by Least Square Method

Property analysis of urban road travel time

Real-time arterial performance measurement using BRT probe data and signal timing data