Abstract:A two-dimensional (2D) cellular automaton (CA) model is proposed to simulate the ferrite-austenite transformation in binary low-carbon steels. In the model, the preferential nucleation sites of austenite, the driving force of phase transformation coupled with thermodynamic parameters, solute partition at the ferrite/austenite interface, and carbon diffusion in both the ferrite and austenite phases are taken into consideration. The proposed model is applied to simulate the ferrite-to-austenite transformation during isothermal heating at 760 degrees C that is in the ferrite and austenite two-phase range, the austenite-to-ferrite transformation during continuous cooling, and carbon diffusion during tempering at different temperatures for an Fe-0.2969 mol.% C alloy. The results show that during the isothermal heating, austenite nucleates and grows. The austenite grains are mostly located at the boundaries of ferrite grains. The carbon concentration in austenite is higher than that in ferrite. The simulated microstructure agrees reasonably well with the experimental observation. During the continuous cooling process, the austenite-to-ferrite transformation occurs accompanied with carbon diffusion. After cooling from the heating temperature of 760 degrees C to room temperature with a cooling rate of 2 degrees C/s, the carbon concentration field is nearly uniform, while a higher cooling rate of 5 degrees C/s results in a non-uniform carbon concentration field. After tempering at different temperatures for 20 min, the uniformity of carbon distribution increases with increasing tempering temperature. The simulation results are used to understand the mechanisms of the observed experimental phenomena that a cold-rolled low-carbon enameling steel presents different yield strengths after different heat treatment processes.

Computer Simulations of Phase Transformation in Steels

Phase Field Simulation for Non-Isothermal Solidification of Multicomponent Alloys Coupled with Thermodynamics Database

Application of Phase-Field Modeling in Solid-State Phase Transformation of Steels

A Multi-Phase Model for Transformation Plasticity Using Thermodynamics-Based Metallurgical Algorithm

Analysis of Phase Transformation Simulation and Prediction of Phase Distribution in High Strength Steel in Hot Stamping

A Cellular Automaton Model Integrated with CALPHAD-based Thermodynamic Calculations for Ferrite-Austenite Phase Transformations in Multicomponent Alloys

Modeling of Ferrite‐Austenite Phase Transformation

Phase Transformation Simulation of High Strength Steel under Hot Stamping Process

A level-set formulation to simulate diffusive solid/solid phase transformation in polycrystalline metallic materials -- Application to austenite decomposition in steels

Study of Phase Transformations and Interface Evolution in Carbon Steel under Temperatures and Loads Using Molecular Dynamics Simulation

A Cellular Automaton Approach to Modeling of Phase Transformation in Quenching of Steels

Multi-phase transformation kinetics of HSLA steels during continuous cooling: experiments and cellular automaton (CA) simulation

Study on the Phase Transformation Simulation of Hot-Stamping

A Review on the Modeling and Simulations of Solid-State Diffusional Phase Transformations in Metals and Alloys

Towards the ab initio based theory of the phase transformations in iron and steel

The phase transformation model of SCM435 steel

Mathematical modelling of phase transformation from hot-deformed austenite in low carbon steels

Modeling of Ferrite-Austenite Phase Transformation Using a Cellular Automaton Model

Fundamentals and Application of Solid-State Phase Transformations for Advanced High Strength Steels Containing Metastable Retained Austenite

Phase-field Modeling of Cyclic Phase Transformations in Low-Carbon Steels

Thermomechanical-Phase Transformation Simulation of High-Strength Steel in Hot Stamping