Abstract:Pristine LiNi0.5Mn1.5O4 and FePO4-coated one with Fd-3m space groups were prepared by a sol-gel method. The structure and performance were studied by X-ray diffraction (XRD) rietveld refinement, scanning electron microscopy (SEM), high resolution transmission electron microscopy (HRTEM), energy dispersive spectrometer (EDS) mapping, electrochemical impedance spectroscopy (EIS) and charge-discharge tests, respectively. The lattice parameters of all samples almost remain the same from the Rietveld refinement, revealing that the crystallographic structure has no obvious difference between pristine LiNi0.5Mn1.5O4 and FePO4-coated one. All materials show similar morphologies with uniform particle distribution with small particle size, and FePO4 coating does not affect the morphology of LiNi0.5Mn1.5O4 material. EDS mapping and HRTEM show that FePO4 may be successfully wrapped around the surfaces of LiNi0.5Mn1.5O4 particles, and provides an effective coating layer between the electrolyte and the surface of LiNi0.5Mn1.5O4 particles. FePO4 (1wt%)-coated LiNi0.5Mn1.5O4 cathode shows the highest discharge capacity at high rate (2C) among all samples. After 80 cycles, the reversible discharge capacity of FePO4 (1wt%) coated LiNi0.5Mn1.5O4 is 117mAhg-1, but the pristine one only has 50mAhg-1. FePO4 coating is an effective and controllable way to stabilize the LiNi0.5Mn1.5O4/electrolyte interface, and avoids the direct contact between LiNi0.5Mn1.5O4 powders and electrolyte, then suppresses the side reactions and enhances the electrochemical performance of the LiNi0.5Mn1.5O4.

Study on Li1-2xNixFePO4 Synthesized by Co-precipitation Method

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Influence of the Ni-Doped on the Electrochemical Performance of LiFePO4

Based on first-principles calculation, study on the synthesis, and performance of Fe–Ni co-doped LiMnPO4/C as cathode material for lithium-ion batteries

Revealing electrochemical performance of Ni doping LiFePO4 composite

Physical Properties and Electrochemical Performance of LiNi X Mn 2-X O 4 Cathode Materials Prepared Using a Precipitation Method

Synthesis and characterization of abundant Ni-doped LiNixMn2-xO4 (x = 0.1-0.5) powders by spray-drying method

Effects of Neodymium Aliovalent Substitution on the Structure and Electrochemical Performance of LiFePO4

Synthesis of Cathode Material LiFePO4 for Rechargeable Lithium-Ion Battery by Co-Precipitation Method

Research on Co-Precipitation Synthesis and Mn2+ Doping of Cathode Materials-LiFePO4

Fe Doped Li1.2Mn0.6-x/2Ni0.2-x/2FexO2 (x≤0.1) As Cathode Materials for Lithium-Ion Batteries

Investigation of Li 3 PO 4 Coating and Nb 5+ Doping Effect on the Crystal Structure and Electrochemical Properties of Ni-Rich LiNi 0.85 Co 0.05 Mn 0.10 O 2 Cathode

Enhanced Electrochemical Property of FePO4-coated LiNi0.5Mn1.5O4 As Cathode Materials for Li-ion Battery

Physical Properties and Electrochemical Performance of Linixmn2-Xo4 Cathode Materials Prepared

Synthesis and electrochemical performance of Mo-doped LiNi0.5Mn1.5O4 cathode material

Effect of Amorphous FePO4 Coating on Structure and Electrochemical Performance of Li1.2Ni0.13Co0.13Mn0.54O2 As Cathode Material for Li-ion Batteries

Advanced Electrochemical Performance of Li[Ni(1/3−x)FexCo1/3Mn1/3]O2 As Cathode Materials for Lithium-Ion Battery

Preparation of Nano-Structured Lifexmn1-Xpo4 (X=0, 0.2, 0.4) by Reflux Method and Research on the Influences of Fe(Ii) Substitution

The Effect of NiO As Graphitization Catalyst on the Structure and Electrochemical Performance of LiFePO4/C Cathode Materials

Electrochemical Performance of LiMnPO4 by Fe and Zn Co-Doping for Lithium-Ion Batteries

Hierarchical LiFe0.98MII 0.02PO4/C (MII = Ni, Mn, Mg) Composites Via Co-Doping for Lithium Ion Batteries