Abstract:Plastic instead of steel technology is one of the important means of automotive lightweighting, which can greatly reduce the weight of the car while ensuring the same performance of the product. For the lightweighting of the automotive all-plastic front-end frame structure, the initial structural design of the front-end frame was carried out by HyperMesh; based on the compromise planning method and entropy weight method, the compromise planning method with weight coefficients was used to unify the planning of each subobjective to obtain the integrated response function, and the minimization of the integrated response function was the objective. The main considerations were the lock limit crash load, the cushion area load, and the pedestrian protection impact load under typical operating conditions, the shape optimization, and topology optimization, respectively. The mass of the sheet metal front-end frame was reduced from the original 10.5 kg to 6.8 kg—a weight reduction of 35.24%. The front-end frame was extracted and the mid-plane was repaired by HyperMesh, the complete mid-plane was meshed, loads and properties were added to the mesh, the front-end frame was subjected to static and modal analysis in the OptiStruct module, and the stiffness and intrinsic frequency were verified. The results show that the smallest first-order mode in the modal analysis is 57.38 Hz, which is much larger than the 30 Hz required before design. The fatigue analysis of the front-end frame was then performed using N-code to derive the damage results; it is concluded that its life is 6122 s, much larger than the specified 1200 s. Through the verification of the relevant resonance test, it is judged that the performance of the test part meets the actual requirements comprehensively by checking the status after the test.

Design Method of Frontal Structure Impact in Concept Phase Based on MADYMO

Concept Analysis and Optimization of Lower Leg Impact for Car Pedestrian Protection

Body Structure Optimization of a Car in the Frontal Crash

Frontal crashworthiness structure analysis and optimization of electric vehicle

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Application of Sub-Structure Method for Automotive Side Impact Simulations

Numerical Simulation and Test Validation of Vehicle Frontal Crash

Simulation of Automobile Offset Frontal Impact and Structure Improvement

The Improvement of Front Cross Member in Vehicle Offset Impact

Development of a Parametric Vehicle Front Structure Model for Pedestrian Impact Simulations

Multi-disciplinary design optimisation considered fluid-structure interaction and life prediction applied in the lightweight carbody structure

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

A Computational Investigation on the Effect of Vehicle Rotation on Driver Injury Metrics in Frontal Offset Crash

A Response-Surface-Based Tool For Vehicle Front-End Design For Pedestrian Impact Protection Using Human Body Model

Research and Analysis of Frontal Collision of Passenger Cars Based on ANSYS

Improvement of vehicle crashworthiness for full frontal impact based on energy flow analysis

Finite Element Analysis on the Lateral Crashworthiness of Car Body Structure

Research on the Optimization of Automobile Plastic Front Frame Structure

Modeling and Simulation of Frontal Crash Performance of a Minibus

Optimization Design of Body Structure in Offset Crash

Improving Design for Crashworthiness of a Minibus