Abstract:In this research the electrochemical performance of Cu, Cu–10Al–10Ni, Cp-Ti and C-steel in 3.5% sodium chloride containing sulfide ions was investigated. Different electrochemical methods such as polarization technique and electrochemical impedance spectroscopy, EIS, were used. Surface examination and morphological studies were employed. The effect of immersion time of the different alloys was extensively studied by EIS. A comparison was made between the electrochemical stability of the different alloys in this media. Polarization measurements reveal that Cp-Ti and Cu–10Al–10Ni alloys possess lower corrosion rates than both Cu and carbon steel. EIS measurements, have shown that a more thicker and resistive passive film is formed on Cp-Ti alloy due to the formation of TiO2 film of duplex nature. The incorporation of Ni in the Cu2O barrier film leads to the stabilization of Cu–10Al–10Ni alloy and the stability is enhanced in the presence of Al. The thickness and resistance of the barrier layer formed on the alloy surfaces increase with the increasing the immersion time. The formation of such passive film on the surface of different alloys was discussed. An equivalent circuit model for the electrode/electrolyte interface under different conditions was proposed. The experimental impedance data were fitted to the theoretical data according to the proposed model.

CORROSIVE EFFECT BY ALLYLTHIOUREA OF BULK NANOCRYSTALLINE INGOT IRON IN AMBIENT DILUTED ACIDIC SULPHATE SOLUTION

Kinetic Analysis on Anodic Polarization Behavior of Nanocrystalline Copper in Na2SO4 Solution

Effect of Sulfate Ions on Anodic Polarization Behavior of Nanocrystalline Copper Bulk

Effect of Thiourea on Bulk Nanocrystallized Ingot Iron in Acidic Sulfate Solution

Corrosion and corrosion inhibition by thiourea of bulk nanocrystallized industrial pure iron in dilute HCl solution

Electrochemical Corrosion Behavior of Bulk Nanostructured Industrial Pure Iron in Sulphuric Acid Solution

Effect of ATU on Nickel Anodic Dissolution and Cathodic Deposition

Effect of Surface Nanocrystallization on the Acid Corrosion and Corrosion Inhibition of Low Carbon Steel

Effect of H3bo3 on Corrosion in 0.01 M Nacl Solution of the Interface Between Low Alloy Steel A508 and Alloy 52 M

Corrosion behavior of Cu-Ni alloy in 55% LiBr solution with different inhibitor

Effect of Corrosion Time on the Synergistic Corrosion of Q235 Steel in Sodium Aluminate Solutions

Effect of Inhibitors on the Critical Pitting Temperature of the High-Entropy Alloy Co1.5CrFeNi1.5Ti0.5Mo0.1

STM in Situ STUDY ON THE DISSOLUTION BEHAVIOR OF AMORPHOUS ALLOY AND ITS STRUCTURE CHARATCTERS OF CORROSION INTERFACE

An Investigation Of A Combined Thiourea And Hexamethylenetetramine As Inhibitors For Corrosion Of N80 In 15% Hcl Solution: Electrochemical Experiments And Quantum Chemical Calculation

Effect of Yttrium on the Corrosion Behaviour of 09crcusb Alloy in Concentrated Sulphuric Acid

Inhibition Action of Allyl Thiourea for Steel in H_2SO_4 Solution

CORROSION OF AMORPHOUS AND NANOCRYSTALLINE Fe-BASED ALLOYS IN NaCl AND H2SO4 SOLUTIONS

Effect of SO2 on the Corrosion Behaviors of CoCrFeNiTi0.5 Alloy Anti-Alkali Metal Sulfate

Effect of Anions on Stress Corrosion Cracking Behaviors of Ultra-High Strength Steel 23Co14ni12cr3mo

Effects of $${{{S}}^{{{2} - }}}$$ S 2 - - and $${{S_2}O_3^{2 - }}$$ S 2 O 3 2 - -Containing Bayer Solutions on Corrosion of 16Mn Low-Alloy Steel at Elevated Temperatures

Corrosion behavior and electrochemical properties of carbon steel, commercial pure titanium, copper and copper–aluminum–nickel alloy in 3.5% sodium chloride containing sulfide ions