Abstract:Compared to cross-linked polyethylene, polypropylene has a thermoplastic property and the advantage of recycling. However, the poor impact resistance at low temperature and the corresponding space charge problem restrict the application of polypropylene with the extruded high voltage direct current (HVDC) cable. Sufficient introduction of the β form of the polypropylene crystal can significantly improve impact resistance at low temperatures. Although it has been widely applied in insulation engineering, the effect of β-crystal on the space charge characteristics of polypropylene has rarely been researched until now. In this paper, a rare earth nucleating agent of β-crystal is employed to modify the performance of polypropylene to investigate the effects of nucleating agent content on β-crystalline, mechanical relaxation, trap, and space charge characteristics of polypropylene. The results of differential scanning calorimeter (DSC) and X-ray diffraction (XRD) tests indicate that the relative content of β-crystal in modified polypropylene increases gradually with the increasing concentration of the nucleating agent, approaching 43.5% when the nucleating agent content has been raised to 0.2 wt %, suggesting appreciable efficiency of the nucleating agent utilized in our research. Scanning electron microscopy (SEM) is utilized to characterize the morphology of β-crystal spherulites, which illustrates that the β-spherulites are in bunchy shape, and the lamellar crystals are parallel to each other without an obvious boundary between them. The results of the space charge test demonstrate that the modified polypropylene can substantially suppress space charge accumulation, which is attributed to an increment of β-crystal content by adopting a rare earth nucleating agent. It is indicated from dynamic mechanical analysis (DMA) measurements that the enhancement of β-crystalline in modified polypropylene can distinctly increase and decrease the β and α relaxation losses, respectively, which proves that the defects in β-crystal and amorphous regions are reduced and increased respectively. Thermally stimulated depolarization current tests further confirm that the number of traps caused by defects in the β-form of polypropylene crystal declines definitely, which dominantly accounts for the suppression of space charge accumulation.

Effect of rare earth β nucleating agent on the properties of polypropylene

Effects of Rare Earth β Nucleating Agent on Properties of High-Impact Polypropylene

Investigation on the Effects of MXene and Β-Nucleating Agent on the Crystallization Behavior of Isotactic Polypropylene

A Novel Β Nucleating Agent and Its Effect on the Crystallization Characteristics of Isotactic Polypropylene

Influence of a Novel Β‐nucleating Agent on the Structure, Morphology, and Nonisothermal Crystallization Behavior of Isotactic Polypropylene

Effects of Α and Β Nucleating Agent Compounds on Properties of Polypropylene

Effect Of Beta-Nucleating Agents On Crystallization And Melting Behavior Of Isotactic Polypropylene

The α-, β-, and γ-polymorphs of polypropylene–polyethylene random copolymer modified by two kinds of β-nucleating agent

Application of a andβnucleating agent in ultra-high impact polypropylene

Crystalline Modification of Isotactic Polypropylene with a Rare Earth Nucleating Agent Based on Ultrasonic Vibration

Advances in research and application of rare earth β-nucleating agents for polypropylene

The Crystallization Morphology and Conformational Changes of Polypropylene Random Copolymer Induced by a Novel β-Nucleating Agent

Influence of compounded α/β-nucleating agents on the crystallization behavior and mechanical properties of isotactic polypropylene

Space Charge Characteristics of Polypropylene Modified by Rare Earth Nucleating Agent for β Crystallization

Application of Β-Form Nucleating Agent for Polypropylene Ⅰ.Effect of Β-Form Nucleating Agent on Crystallization Behavior and Mechanical Property of Polypropylene

The Effect of Rare Earth β Nucleating Agent and Molten Temperature on the Structure and Toughness of iPP

Coeffect of Different Core–shell Particles and Β Nucleating Agent on the Mechanical and Thermal Properties of Polypropylene Random Copolymer Composites

Relationship Between Mechanical Properties and Crystalline Structure of PPR/iPP Blends Modified with β-Nucleator

Influence of Nucleation on the Brittle‐ductile Transition Temperature of Impact‐resistant Polypropylene Copolymer: from the Sight of Phase Morphology

THE MECHANICAL AND MELTING CRYSTALLIZATION PROPERTIES OF β-FORM POLYPROPYLENE/POE BLENDS

Effects of an Organic Phosphorus Nucleating Agent on Crystallization Behaviors and Mechanical Properties of Poly(Propylene)