Abstract:To investigate the characteristics of optimal fail-safe structures subjected to single and multi-member damage scenarios, we consider a pin-jointed cantilever truss with all members directly connected from the load point to the boundary. Two problem formulations are considered—minimizing the compliance with a volume constraint and minimizing the volume with stress constraints. Whilst these formulations produce equivalent structures for traditional truss design problems, we find that this is not always the case in the fail-safe setting. Analytical solutions are developed for a three-bar truss under both problem formulations. Damage is modelled as the complete removal of any one member, and a minmax problem is constructed to minimize the compliance or volume of the structure for the worst-case damage scenario. These new analytical solutions provide much needed benchmarks for numerical fail-safe methods. The problems are extended to n -bar systems with damage to multiple members. Results show that as the structural complexity (the number of members in a system) increases, the optimum fail-safe structure tends towards a variation of the nominal two-bar design with overlapping members. From these observations, we then approach the idea of full redundancy through the introduction of parallel substructures into a more complex truss design. We compare our fully redundant truss design with a benchmark fail-safe solution and show that the fully redundant design has significantly better performance and with fewer members. Practically, this suggests that fully redundant structural designs are highly efficient and have the additional benefit of only requiring the computation of the nominal solution.

New judgment method on dynamic instability of truss structures: stress rate method

Quasi-static Deployment Simulation for Deployable Space Truss Structures

Distribution of Initial Pre-Stress and Stability Analysis of Suspen-Dome

Vulnerability Assessment and Failure Scenarios Identification of Truss Structures

Influence of torsion stiffness of spatial truss string system on structural stability

STABILIZATION ANALYSIS OF UNSTABLE DEPLOYABLE SPACE TRUSS STRUCTURES

Influence of damage On dynamical elastic-plasticity stability of BSS

Experimental Study and Numerical Analysis of a Novel Serrated-and-plate Truss Structure

Optimal fail-safe truss structures: new solutions and uncommon characteristics

Prestress design of spatial cable-truss tensile structures with annular plane

New Advances In Theory Of Stability Of Steel Structures

STUDY OF THE STRESS DISTRIBUTION AND MECHANICAL PROPERTIES OF THE BEAM-COLUMN JOINT IN STEEL ROOF TRUSS BASED ON FULL-SCALE TESTS

Assessing Key Structural Stiffness of Existing Space Trusses Based on Optimized Simple Static Loadings

NSF-Based Analysis of the Structural Stressing State of Trussed Steel and a Concrete Box Girder.

NUMEIUCAL STUDY ON STABILITY BEHAVIOR AND FAILURE MECHANISM OF STEEL TUBE TRUSS-ARCHES

Numerical Study on LDLT Decomposition-Based Damage Locating Vector Method for Truss Structures

Axial Strain Accelerations Approach for Damage Localization in Statically Determinate Truss Structures.

An Algorithm for Damage Localization in Steel Truss Structures: Numerical Simulation and Experimental Validation

Damage identification of large-scale space truss structures based on stiffness separation method

Model updating experiment of space truss using global and local dynamic information

Fatigue Damage Analysis of Steel Truss Suspension Bridge Under Non-Stationary and Non-Gaussian Buffeting