Abstract:In the development of advanced steel, accurate and detailed knowledge about the kinetics of phase transformations and microstructure formation is critical. The critical issue in pearlite-austenite transformation is the consideration of diffusional paths of the alloy element. Simulation has been an available method to study the diffusion of alloy elements and the migration rate of the phase boundary in the complex morphological evolution of austenite growth. The isothermal pearlite-austenite transformations at 720 and 740 degrees C in Fe-0.6%C-2%Mn (mass fraction) alloy were studied by phase-field methods based on MICRESS. At different temperatures, the effects of diffusional paths on the austenite transformation were discussed. To achieve a semiquantitative verification of the simulated results, the migration rates of the austenite/pearlite boundary at 720 and 740 degrees C were estimated from the experimental kinetics curves by fitting the JMA equation. By measuring the Mn profile in austenite, the modes of the austenization at 720 and 740 degrees C can be verified as partitioned local equilibrium (PLE) and non-partitioned local equilibrium (NPLE) modes. The heterogeneous distribution of Mn in austenite at 740 degrees C can be observed with STEM-EDS. However, the homogenous distribution of Mn can be found near the pearlite/austenite boundary in austenite at 720 degrees C. The cases considering the gamma, alpha, and interface-diffusional paths were simulated by phase-field methods to compare with the migration rates of the austenite/pearlite boundary. Because carbon is an interstitial element in steel and has an interstitial diffusional mechanism, it can be speculated reasonably that the diffusion of C mainly proceeded in austenite and ferrite through the considerations of the atom-size of carbon and the experimental results. Phase-field methods were used to study Mn diffusion in the lamellar pearlite-austenite transformation. With the analysis of the experimental estimations, the interface-diffusional path was observed as the dominant path for the Mn diffusion. It is because the Mn atoms have greater diffusivity in interfaces than in gamma or alpha-diffusional paths. Furthermore, the diffusional activation energy is closely related to the diffusivity of Mn at the interface. Moreover, compared with the gamma-diffusional path, the diffusional flux of Mn in ferrite is much larger than that in austenite. Thus, it can be concluded that the contribution of the alpha-diffusional path to the migration rate of the pearlite/austenite boundary is larger than that of the gamma-diffusional path. As a result, considering the alpha-diffusional path in the thermodynamics analysis under NPLE mode makes more sense. However, ignoring the interface- and alpha-diffusional path, which is different from the traditional cognition in PLE mode, will result in a magnitude error for the thermodynamics analysis.

A Calculation of Partitional Local Equilibrium/negligible Partitional Local Equilibrium Boundaries in Fe–C–X Systems

Transition between partitioned and unpartitioned growth of proeutectoid ferrite in Fe–C–Xi systems

A Calculation Method of Ple/Nple Transition Temperature of Gamma -> Alpha Transformation in Fe-C-X-I System

Application of the Thermodynamic Extremal Principle to Diffusion-Controlled Phase Transformations in Fe-C-X Alloys: Modeling and Applications

PLE/NPLE transition temperature of gamma > alpha transformation in Fe C X alloy steel under hot deformation condition

Thermodynamic Analysis of the Fe-B-C Ternary System and an Evaluation of the Grain Boundary Segregation Behavior of B and C

Effect of Interfacial Mn Partitioning on Carbon Partitioning and Interface Migration During the Quenching and Partitioning Process

Thermodynamics of Fcc–fct Martensitic Transformation in Mn–X(X = Cu,Fe) Alloys

Critical evaluation and thermodynamic modeling of the Fe–P and Fe–C–P system

Thermodynamic Assessment of the Fe–Mn–Ni System and Diffusion Mobility of Its Face-Centered Cubic Phase

Application of the Thermodynamic Extremal Principle to Massive Transformations in Fe-C Alloys

Simplified Thermodynamic Model for Pro—Eutectoid Ferrite Formation in Multicomponent Structrual Steel

Phase Field Study of the Diffusional Paths in Pearlite-Austenite Transformation

A general mixed-mode model for the austenite-to-ferrite transformation kinetics in Fe–C–M alloys

Simplified thermodynamic model for pro-eutectoid ferrite formation in multicomponent structural steel

A Simple Calculation Method of Driving Force of Gamma ->Alpha Transformation in Fe-C-X-I Systems with Orthoequilibrium and Paraequilibrium Models

Interface Motion and Interface Mobility of the Partitioning Phase Transformations in Fe-Mn-C and Fe-C Alloys: A Cyclic Phase Transformation Approach

On the Transition Between Grain Boundary Ferrite and Bainitic Ferrite in Fe–C–Mo and Fe–C–Mn Alloys: the Bay Formation Explained

Partition and Non-Partition Transition of Austenite Growth from a Ferrite and Cementite Mixture in Hypo- and Hypereutectoid Fe-C-Mn Alloys

Application of the stagnant stage concept for monitoring Mn partitioning at the austenite-ferrite interface in the intercritical region for Fe-Mn-C alloys

Phase-field analysis of quenching and partitioning in a polycrystalline Fe-C system under constrained-carbon equilibrium condition