Abstract:Homogenous charge compression ignition (HCCI) combustion is a low temperature combustion process which combines high combustion efficiency with ultra-low [Formula: see text] raw emissions. Steep increases of the in-cylinder pressure and unstable combustion sequences at the limits of the operating range can damage the engine and limit the use of HCCI to part load operation. This can be done using closed loop combustion control based on combustion parameters like the indicated mean effective pressure and the combustion phasing. Since in-cylinder pressure sensors are expensive components and therefore not suitable for series application, ion current sensors can be used as an additional source of information about the combustion. Combustion analysis using methods similar to those used in pressure based measurements can be implemented using an online analysis of the ion current signal. In this study, the ion current sensor will be examined for its suitability for combustion control under HCCI conditions with lean air/fuel ratios and high compression ratios. Research has found that the ion current signal is strongly depended on the boundary conditions. Especially the air/fuel ratio which plays an important role for signal strength during the combustion process. When using valve timings with negative valve overlap in combination with a fuel pre-injection, a further peak of the ion current signal close to the gas exchange top dead center can be found in addition to the one during combustion. At the same time, it is hard to extract information from the cylinder pressure signal during NVO. Under lean conditions this peak even exceeds the signal during combustion. This study analyzes the ion current signal during NVO and its potential to be used for future combustion control concepts. The ion current signal shows potential to stabilize HCCI combustion at high loads. However, the prediction of late combustion cycles is still challenging.

Research on Ion Current Signal Based on Wavelet Threshold De-Noising Method

Extraction of Diesel Combustion Signal in the Cylinder

Research and Application of the Method of Ionic Signal to SI Engine

Investigation on Detection of Misfire and Knock of Spark I gniton EngineUsing Ionic Current Method

A Denoise Method of Electrical Discharge Machining Gaps Signal for Non-Conductive Engineering Ceramics Based on Wavelet Mma

Experimental Simulation on Detection of Abnormal Ignition Using Ionic Current Method

Investigation on Characteristics of Ionization Current in a Spark-Ignition Engine Fueled with Natural Gas–hydrogen Blends with BSS De-Noising Method

Investigation on Characteristics of Ion Current in a Methanol Direct-Injection Spark-Ignition Engine

Analysis on Mechanisms of Ionic Signal in Vicinity of Ignition Electrodes

Analysis of ion current signal during negative valve overlap of HCCI combustion with high compression ratio

Application of Blind Source Separation in Ion Current Signal Analysis of Spark Plug

Ionic current for detecting burning signals in combustion chamber of gasoline engine

Investigation of the Detection of Knock and Misfire of a Spark Ignition Engine with the Ionic Current Method

A Study on Misfire Detection for Electronically Controlled Gasoline Engine Based on Wavelet Transform Technique

Misfire Diagnosis of Methanol Engine with Ion Current Method

GDI HCCI Combustion Detection Using Ion Sensing Technology

Analysis on the Characteristics of the Ionic Signal of Combustion and Misfire in a SI Engine

Study on the Relationship Between the Ionic Signal and the Air/Fuel Ratio

Investigation of Air-Fuel Ratio Control Using Ionic Current Signal

Relationship Between Ionization Current in Post-Flame and Temperature Around Electrodes

Spark Plug as an Ionization Sensor in Engine Knock Detection