Abstract:Natural gas has become the most widely used alternative energy for engines because of its low emission pollution and sufficient energy reserve. In order to improve the thermal efficiency of the natural gas engine, it is necessary to increase the compression ratio, but knock restricts the increase of the engine compression ratio. The main knock detection method of engine is to use knock sensor. However, the body vibration detected by the knock sensor contains a lot of interference noise, which brings bad effect on the accuracy of knock detection. Thus, in this paper, a knock recognition method based on wavelet transform (WT) and variational mode decomposition (VMD) algorithm is proposed to process the knock sensor signal and extract the knock feature. Based on the test bench of natural gas engine, experimental investigation of knock combustion characteristics was conducted by adjusting the spark timing, and simultaneously collects cylinder pressure signal and knock sensor signal. Burg algorithm based on Auto-regressive (AR) model was used to extract the knock characteristic frequency of the research engine. Then, wavelet transform and variational mode decomposition algorithm were employed to process the knock sensor signal to remove the interference noise and extract the knock feature. Maximum amplitude of pressure oscillation (MAPO) was selected as the knock intensity evaluation index of cylinder pressure signal. Then, taking the evaluation result of the knock intensity of cylinder pressure signal as reference, the root-mean-square of the knock characteristic signal was used as knock intensity evaluation index of knock sensor signal to determine the knock intensity classification of the knock sensor signal. The results show that the proposed method can effectively extract the knock feature from the knock sensor signal and realize the accurate engine knock recognition. The recognition accuracy is higher than the most existing knock recognition methods.

Investigation on Detection of Misfire and Knock of Spark I gniton EngineUsing Ionic Current Method

Investigation of the Detection of Knock and Misfire of a Spark Ignition Engine with the Ionic Current Method

Spark Plug as an Ionization Sensor in Engine Knock Detection

The Investigation about a New Type of Misfire Detection Method in an Engine

Comparison of Knock Detecting between Ionic Current Method and Block Vibration Method

Research and Application of the Method of Ionic Signal to SI Engine

Analysis on the Characteristics of the Ionic Signal of Combustion and Misfire in a SI Engine

Investigation on Characteristics of Ion Current in a Methanol Direct-Injection Spark-Ignition Engine

Ionic current for detecting burning signals in combustion chamber of gasoline engine

Experimental Simulation on Detection of Abnormal Ignition Using Ionic Current Method

Misfire Diagnosis of Methanol Engine with Ion Current Method

Research on Ion Current Signal Based on Wavelet Threshold De-Noising Method

Experimental Study of Influence of Bias Voltage on Ionic Current

Detection of Engine Misfire by Wavelet Analysis of Cylinder-Head Vibration Signals

Study of On-Board Misfires Diagnosing Strategy of Electronically Controlled Engine

Knock Recognition of Knock Sensor Signal Based on Wavelet Transform and Variational Mode Decomposition Algorithm

Real-Time Angular Velocity-Based Misfire Detection Using Artificial Neural Networks

Design of Programmable Sweep Signal Source used in Automotive Ignition Coil Misfire Detection

Misfire detection of an internal combustion engine based on vibration and acoustic analysis

A Study on Misfire Detection for Electronically Controlled Gasoline Engine Based on Wavelet Transform Technique

Study on a New Method of the Air/Fuel Ratio Detection