Abstract:Graphene nanoribbons have attracted attention for their novel electronic and spin transport properties1-6, and because nanoribbons less than 10 nm wide have a band gap that can be used to make field effect transistors. However, producing nanoribbons of very high quality, or in high volumes, remains a challenge. Here, we show that pristine few-layer nanoribbons can be produced by unzipping mildly gas-phase oxidized multiwalled carbon nanotube using mechanical sonication in an organic solvent. The nanoribbons exhibit very high quality, with smooth edges (as seen by high-resolution transmission electron microscopy), low ratios of disorder to graphitic Raman bands, and the highest electrical conductance and mobility reported to date (up to 5e2/h and 1500 cm2/Vs for ribbons 10-20 nm in width). Further, at low temperature, the nanoribbons exhibit phase coherent transport and Fabry-Perot interference, suggesting minimal defects and edge roughness. The yield of nanoribbons was ~2% of the starting raw nanotube soot material, which was significantly higher than previous methods capable of producing high quality narrow nanoribbons1. The relatively high yield synthesis of pristine graphene nanoribbons will make these materials easily accessible for a wide range of fundamental and practical applications.

Narrow Graphene Nanoribbons from Carbon Nanotubes

Large-Scale Production Of Graphene Nanoribbons From Electrospun Polymers

Facile Synthesis of High Quality Graphene Nanoribbons

Longitudinal unzipping of carbon nanotubes to form graphene nanoribbons

Sub-10-nm graphene nanoribbons with atomically smooth edges from squashed carbon nanotubes

Rational Fabrication of Graphene Nanoribbons Using a Nanowire Etch Mask

Field-effect transistors based on single graphene oxide nanoribbon from longitude-unzipped carbon nanotubes

Graphene Nanoribbons Grown in Hbn Stacks for High-Performance Electronics

Chemically Derived, Ultrasmooth Graphene Nanoribbon Semiconductors

Graphene Nanoribbon Devices Produced by Oxidative Unzipping of Carbon Nanotubes

Graphene Nanoribbons: Current Status, Challenges and Opportunities

Twisting Graphene Nanoribbons into Carbon Nanotubes

Efficient Synthesis of Graphene Nanoribbons Sonochemically Cut from Graphene Sheets

Electronic, Magnetic and Transport Properties of Graphene Ribbons Terminated by Nanotubes

Graphene Nanoribbons from Tetraphenylethene-Based Polymeric Precursor: Chemical Synthesis and Application in Thin-Film Field-Effect Transistor

“White Graphenes”: Boron Nitride Nanoribbons via Boron Nitride Nanotube Unwrapping

Oriented Graphene Nanoribbons Embedded in Hexagonal Boron Nitride Trenches

Single-crystalline nanoribbon network field effect transistors from arbitrary two-dimensional materials

Carbon Nanoelectronics: Unzipping Tubes into Graphene Ribbons

Unzipping Carbon Nanotubes to Sub-5-nm Graphene Nanoribbons on Cu(111) by Surface Catalysis

Aligned Graphene Nanoribbons and Crossbars from Unzipped Carbon Nanotubes