Abstract:Equal channel angular expansion extrusion with spherical cavity (ECAEE-SC) was introduced as a novel severe plastic deformation (SPD) technique, which is capable of imposing large plastic strain and intrinsic back-pressure on the processed billet. The plastic deformation behaviors of commercially pure aluminum during ECAEE-SC process were investigated using finite element analysis DEFORM-3D simulation software. The material flow, the load history, the distribution of effective strain and mean stress in the billet were analyzed in comparison with conventional equal channel angular extrusion (ECAE) process. In addition, single-pass ECAEE-SC was experimentally conducted on commercially pure aluminum at room temperature for validation, and the evolution of microstructure and microhardness of as-processed material was discussed. It was shown that during the process, the material is in the ideal hydrostatic stress state and the load requirement for ECAEE-SC is much more than that for ECAE. After a single-pass ECAEE-SC, an average strain of 3.51 was accumulated in the billet with homogeneous distribution. Moreover, the microstructure was significantly refined and composed of equiaxed ultrafine grains with sub-micron size. Considerable improvement in the average microhardness of aluminum was also found, which was homogenized and increased from HV 36.61 to HV 70.20, denoting 91.75% improvement compared with that of the as-cast billet.

Preparation of Semi-solid MB15-RE Billets by Equal Channel Angular Extrusion

Preparing Mg-6Al alloy with high mechanical properties and fine grains by equal channel angular extrusion

Preparation of Mg-Al Series Magnesium Alloy Semi-solid Billets and its Thixo-extrusion Forming

Semisolid Microstructural Evolution Of Equal Channel Angular Extruded Mg-Al Alloy During Partial Remelting

Preparation of Semi-solid AZ91D Billets by new SIMA Method

Preparation of semi-solid billet of magnesium alloy and its thixoforming

Application of Equal Channel Angular Extrusion to Semi-solid Processing of AZ91D Magnesium Alloy

Microstructure Evolution of AZ91D Magnesium Alloy Semi-solid Billets Prepared by a New SIMA Method

Reheating Microstructure of Refined AZ91D Magnesium Alloy in Semi-Solid State

Microstructural evolution and mechanical properties of AZ31 Mg alloy fabricated by a novel bifurcation-equal channel angular pressing

Preparation of Az91d Magnesium Alloy Semi-Solid Billet by New Strain Induced Melt Activated Method

Numerical Simulation of Semi-Solid Billet Preparation by Equal Channel Angular Extrusion

Research on Semi-Solid Isothermal Treatment of AM60 Magnesium Alloy Processed by Severe Plastic Deformation

Study of reheated microstructure of AZ91D magnesium alloy

Effects of ECAE Temperature and Billet Orientation on the Microstructure, Texture Evolution and Mechanical Properties of a Mg–Zn–Y–Zr Alloy

Effect of Solution Treatment on Microstructure Evolution and Mechanical Properties of Mg-6.0Zn-0.6Y-0.5Zr Alloy Processed by Equal Channel Angular Extrusion

Preparation of Semi-Solid Billet of ZW61 Alloy by Equal Channel Angular Extrusion

The Microstructure and Mechanical Properties of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion

Application of Equal Channel Angular Extrusion to Semi-Solid Processing of Magnesium Alloy

Severe plastic deformation of commercially pure aluminum using novel equal channel angular expansion extrusion with spherical cavity