Abstract:Herein the edge effect from the traction-free boundary condition is utilized to direct the spontaneous surface wrinkling. This boundary condition is attained by a simple combination of mechanical straining and selective exposure of polydimethylsiloxane (PDMS) substrate to O2 plasma (OP) through a copper grid. When the strained PDMS sheet is subjected to selective OP treatment, a patterned heterogeneous surface composed of the OP-exposed "hard" oxidized SiOx region (denoted as D1) and the OP-unexposed "soft" region (denoted as D2) is produced. The subsequent full release of the prestrain (ε(pre)) leads to the selective wrinkling in D1, rather than in D2. It is seen that even in D1, no wrinkling occurs in the vicinity of the D1 edge that is perpendicular to the wavevector. Furthermore, the average wrinkle wavelength in D1 (λ(D1)) is smaller than that of the exposed copper grid-free blank area (λ(blank)). This wavelength decrement between λ(D1) and λ(blank), which can be used to roughly estimate the edge-effect extent, increases with the applied mesh number of copper grids and exposure duration, while decreases with the increase of ε(pre). Meanwhile, there exists a decrease in the amplitude of the patterned wrinkles, when compared with that of the blank region. Additionally, hierarchical wrinkling is induced when the strain-free PDMS substrate is selectively exposed to OP, followed by uniaxial stretching and the subsequent blanket exposure. Consequently, oriented wrinkles perpendicular to the stretching direction are generated in D2. With respect to D1, no wrinkling happens or orthogonal wrinkles occur in this region depending on the applied mesh number, exposure duration, and ε(pre). In the above wrinkling process, the combinative edge effects in two perpendicular directions that are involved sequentially have been discussed.

Feature development on prepatterned elastomer surfaces upon ion implantation

Chemical Modification on Top of Nanotopography to Enhance Surface Properties of PDMS

Fabrication of Patterned Polymer Resists for Ion Etching by Using Dewetting

Controlled Formation of Surface Patterns in Metal Films Deposited on Elasticity-Gradient PDMS Substrates.

Fast Digital Patterning of Surface Topography Toward Three-Dimensional Shape-Changing Structures

Rapid prototyping of PDMS microdevices via <i></i>PLAT on nonplanar surfaces with flexible hollow-out mask

Tunable patterning of microscale particles using a surface acoustic wave device with slanted-finger interdigital transducers

Non-lithographic Patterning of Phage-Displayed Peptides with Wrinkled Elastomers.

Patterned Microstructure Array Fabrication By Using A Novel Standing Surface Acoustic Wave Device

Designing mamdani type fuzzy rule using a collaborative FCM scheme

Fabrication of Micro-wavy Patterned Surfaces for Enhanced Cell Culturing☆

Implementation of high‐performance, freestanding flexible film masks through photosensitive polyimide for arbitrary surface micropatterns creation

Wettability patterning in microfluidic devices using thermally-enhanced hydrophobic recovery of PDMS

Deformation‐induced Photo‐Programmable Pattern of Polyurethane Elastomers Based on Poisson Effect

UV-activated surface modification of photo-cleavage polymer for contact printing applications

Controlled Free Edge Effects in Surface Wrinkling Via Combination of External Straining and Selective O-2 Plasma Exposure

Low-temperature plasma etching of high aspect-ratio densely packed 15 to sub-10 nm silicon features derived from PS-PDMS block copolymer patterns

Engineering Surface Patterns with Shape Memory Polymers: Multiple Design Dimensions for Diverse and Hierarchical Structures

Protein patterning by micromachined silicon embossing on polymer surfaces

Microscale investigation on the wettability and bonding mechanism of oxygen plasma-treated PDMS microfluidic chip

Parallel Concentric Wrinkled Polydimethylsiloxane Patterns and Their Potential Biomedical Applications