Abstract:In recent years, driven by the rapid growth of global Internet traffic, optical networks are evolving to provide higher capacities. To enlarge transmission capacity, researchers focused on the dimension of space and proposed the concept of space-division multiplexing (SDM) by introducing multicore fiber and few-mode fiber into optical networks. In SDM networks, one of the main challenges is the crosstalk among SDM (core and mode) channels, which degrades signal quality. This degradation has a serious impact on routing and resource allocation. Previous studies have mostly been confined to the routing algorithms for crosstalk reduction but few focus on the re-optimization mechanisms in SDM networks, defined as re-routing the existing lightpaths to minimize the overall crosstalk without traffic disruption. In this paper, by analyzing the re-routing signaling processes of two straightforward serial re-optimization mechanisms, we find that the signaling interaction between node controllers and serial re-routing execution leads to long re-optimization times, which makes lightpath re-optimization impossible for practical use. In order to achieve fast lightpath re-optimization for crosstalk reduction in SDM networks, we propose a novel software-defined networking (SDN) based parallel lightpath re-optimization mechanism, enabled by high-precision time synchronization. The basic idea of our proposed parallel lightpath re-optimization mechanism is to make all the nodes execute the switching operations co-ordinately with the help of network time synchronization. Besides, we propose two key algorithms to achieve parallel re-optimization: a simulated annealing algorithm to determine the re-routing sequence of the lightpaths and a time arrangement algorithm to determine the exact time points of the switching operations at each node. Finally, we conduct a prototype experiment and large-scale network simulations to evaluate the performance of the proposed mechanism. The results demonstrate that our parallel re-optimization mechanism can reduce the overall crosstalk in a much shorter time by up to three orders of magnitude compared with the conventional serial mechanisms and thus is more practical for real applications.

Parallel Probing: Dynamic and Constant Time Setup Procedure in Circuit Switching NoC

Parallel Probe Based Dynamic Connection Setup in TDM NoCs

MultiCS: Circuit Switched NoC with Multiple Sub-Networks and Sub-Channels.

Concept and Design of Exhaustive-Parallel Search Algorithm for Network-on-Chip.

Exploration of Generalized Circuit Switching Optical Network-On-Chip Architecture

An Efficient Probe-Based Routing for Content-Centric Networking

Simultaneous Progressing Switching Protocols for Timing Predictable Real-Time Network-on-Chips

Probing-Based Two-Hop Relay With Limited Packet Redundancy

Analysis and Evaluation of Circuit Switched NoC and Packet Switched NoC

Capacity and Delay of Probing-Based Two-Hop Relay in MANETs.

A Low-Latency and Low-Power Hybrid Scheme for On-Chip Networks

Fast Parallel Lightpath Re-Optimization for Space-Division Multiplexing Optical Networks Based on Time Synchronization

Hybrid Circuit-Switched NOC for Low Cost On-Chip Communication

A Cost-Effective Scheme for Network-on-Chip Router and Interconnect Testing

A New Unicast-Based Multicast Scheme for Network-on-Chip Router and Interconnect Testing

Switch Design and Implementation for Network-on-Chip

CeGen: A Cost-Effective Probe Generation Scheme for Rule Verification in SDN

Partial Probing for Scaling Overlay Routing

Non-adaptive Fault Diagnosis for Low-Degree Networks Via Lightpath Probing Method

Concurrent Testing for Heterogeneous-Cores in Network-on-Chips

ParaNSim: a Parallel Network-on-Chip Simulator