Abstract:Mg(BH4)2 was previously studied as a promising hydrogen storage material, because of its high gravimetric storage capacities for hydrogen and suitable thermodynamic properties. Mg(BH4)2 began to decompose at about 300 ℃, and formed MgB2 at the end of hydrogen desorption process with the weight content of 14.9% of hydrogen lost. Aside from the prominent hydrogen storage property, the decomposition process from Mg(BH4)2 to MgB2 can be a potential method for fabricating superconducting MgB2 at a low sintering temperature. In this paper, MgB2 bulk was prepared by an in-situ reaction, using the Mg(BH4)2 pressed block as a precursor. The resistance change of the sample was monitored during the Mg(BH4)2 decomposition process and the resistance-temperature (R-T) curve of this process was recorded. Phase of MgH2, Mg and B were formed as the block slowly release its hydrogen before MgB2 occurred. According to the R-T curve, the phase formation of MgB2 started in a relatively low temperature of 410 ℃. Because MgB2 was critically formed by Mg and B derived from Mg(BH4)2, we can compare our formation temperature with previous study on MgB2 prepared by Mg and B in different particle size. The fitting result indicated that the particle size of Mg and B harvest from Mg(BH4)2 decomposition was only 3.4 nm on average. The nearly atomic level mixture of Mg and B resulted in a high chemical reactivity, which was the main reason for low sintering temperature. X-ray diffraction results showed that the purity of MgB2 was 95.2%, and the size of MgB2 grains was 10–18 nm. SEM images showed that the MgB2 bulk had a porous structure and poor connectivity, which was caused by large amount the hydrogen release during the decomposition. MgB2 nanofibers can also be observed inside the bulk. In the superconductivity test, the superconducting transition temperature of the bulk was 35 K. After all, such in situ method to fabricate MgB2 showed a great advantage in some aspects, as its low-cost precursors, low sintering temperature, small grain-size and high superconducting transition temperature in the formed MgB2, which have the potential in industrial scale fabrication of MgB2 bulks and wires.

Low-temperature synthesis of superconducting nanocrystalline MgB2

Low-Temperature Synthesis of Superconducting Nanocrystalline<mml:math xmlns:mml="http://www.w3.org/1998/Math/MathML"><mml:msub><mml:mtext>MgB</mml:mtext><mml:mn mathvariant="bold">2</mml:mn></mml:msub></mml:math>

Low Temperature Synthesis of MgB2

Phase formation of polycrystalline MgB2 at low temperature using nanometer Mg powder

Low-temperature Sintering to Fabricate MgB2 by Using Mg(BH4)2 As Precursor

Low-temperature Synthesis of TiB2 Nanocrystals Using TiO2 ,LiBH4 and Mg

Superconductivity Near 35 K in Aligned Amorphous Magnesium-Doped BMgx Nanowires

Aligned single crystal MgB<sub>2</sub> nanowires

High-Temperature Synthesis of Superconducting MgB2 Materials in a Centrifuge

ChemInform Abstract: Low Temperature Mass Production of Superconducting MgB2 Nanofibers from Mg(BH4)2 Decomposition and Recombination.

Synthesis of Boron and Boride Compounds Nanowire Arrays by Chemical Vapor Deposition

In Situ Resistance Analysis of MgB2 Formation Process from Mg(BH4)2

Self-Propagating High-Temperature Synthesis of MgB2 superconductor: A Review

High-Pressure Synthesis of Mgb2 Superconductor with T-C above 39 K

Method for preparing magnesium diboride superconductive material body

The mechanism of pore formation in superconducting MgB2 synthesized at low temperature by in-situ process

MgB2 superconductor thin films on Si and Al2O3 substrates

Effect of synthesis temperature on superconducting properties of n-SiC added bulk MgB2 superconductor

In Situ Epitaxial MgB2 Thin Films for Superconducting Electronics

Influences of Heat Treatment and Doping on Microstructure and Superconducting Properties of MgB2 Superconductor

Study of high temperature resistivity and thermal stability of superconductor MgB2