Abstract:The main obstacle in synthesizing bismuth ferrite is the presence of secondary phases. This paper presents the results of the effect of an unusual chelating agent (polyacrylic acid) on the synthesis of pure and very crystalline BiFeO3 (BFO) nanoparticles. The common chelating system citric acid/ethylene glycol was also evaluated here. The structural (X-ray diffraction and Raman spectroscopy), microstructural and magnetic characteristics were studied. The high resolution XRD confirmed the high purity (>96% in 500 °C) and very crystalline nanoparticulate BFO, without adding any excess of Bi2O3 during the synthesis neither later steps to eliminate secondary phases, i.e., acid leaching or thermal treatment. Thus, the high effectiveness of polyacrylic acid (PAA) as a novel chelating agent in BFO initial crystallization yielded the BFO phase at a temperature lower than that reported in the literature. The nanoparticles (NP) show a distorted R3c lattice, due to the deformation effect markedly at the lower temperature of synthesis (350 °C), diminishing as the synthesis temperature increases. Raman spectra confirmed the R3c ferroelectric phase of BFO nanoparticles. Room temperature magnetic measurements showed a remarkable ferromagnetic behavior, with a visible saturation magnetization as a result of the small particles.

Synthesis of Bismuth Ferrite Nanoparticles Via a Wet Chemical Route at Low Temperature

Low-temperature synthesis of BiFeO3 nanoparticles by ethylenediaminetetraacetic acid complexing sol–gel process

Synthesis and Characterization of Bismuth Ferrite (bifeo3) Nanoparticles by Solution Evaporation Method

Low temperature synthesis of high purity nanoscaled BiFeO3 by a fast polymer solution method and their ferromagnetic behavior

Selective Synthesis on Structures and Morphologies of Bixfeyoz Nanomaterials with Disparate Magnetism Through Time Control

Low-temperature Synthesis of BiFeO3 Nanopowders Via a Sol–gel Method

Magnetic and Optical Properties of Multiferroic Bismuth Ferrite Nanoparticles by Tartaric Acid-Assisted Sol–gel Strategy

Synthesis and Magnetic Property of Submicron Bi2fe4o9

Size-controlled Synthesis of BiFeO 3 Nanoparticles by a Facile and Stable Sol–gel Method

Solid State Synthesis of NiFe_2O_4 Nanoparticles at Low Temperature

Solid State Synthesis of CoFe2O4 Nanoparticles at Low Heating Temperatures

Multiferroic Bismuth Ferrite Nanoparticles: Rapid Sintering Synthesis, Characterization, and Optical Properties

Tunable Synthesis of Bismuth Ferrites with Various Morphologies

A Simple Solution Route to Control Synthesis of Fe3O4 Nanomaterials at Low Temperature and Their Magnetic Properties

Co-Precipitation Synthesis of BiFeO<sub>3</sub> Powders

A Facile Route to the Synthesis of BiFeO3at Low Temperature

BiFeO3 Nanoparticles Prepared by NaNO3-Assisted Low-Heating Temperature Solid State Reaction Method

Bi2fe4o9 Nanoparticles: Preparation By Hydrothermal Method And Characterization

Low‐temperature Preparation of Bismuth Ferrite Microcrystals by a Sol‐gel‐hydrothermal Method

Ferromagnetic and photocatalytic properties of pure BiFeO 3 powders synthesized by ethylene glycol assisted hydrothermal method

Ethanol-assisted hydrothermal synthesis and characterization of BiFeO 3 nanopowders