Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

Design and Analysis of Compound-Structure Permanent-Magnet Synchronous Machine Used for Hybrid Electric Vehicles

Field-circuit Coupled Design and Analysis for Permanent Magnet Synchronous Motor System Used in Electric Vehicles

Efficiency Optimization of PMSM Drives Using Field-Circuit Coupled FEM for EV/HEV Applications

Optimization Design of an Interior Permanent-Magnet Synchronous Machine for a Hybrid Hydraulic Excavator

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

Optimized Design of High Torque Density Permanent Magnet Synchronous Motor with Halbach Magnet

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Multi-objective Optimization Design of Hybrid Excitation Double Stator Permanent Magnet Synchronous Machine

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Performance Analysis of Magnetically Geared Permanent Magnet Brushless Motor for Hybrid Electric Vehicles

Design Consideration of Fractional Slot Concentrated Winding Interior Permanent Magnet Synchronous Motor for EV and HEV Applications

Performance Comparison and Optimization of a PMSM Based on Hybrid-Type Permanent Magnet with Two Kinds of Rotor Topology

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Design and analysis of double-permanent-magnet enhanced hybrid stepping machine with tangential and radial magnetization

Design of in-wheel permanent magnet synchronous motor with concentrated fractional-slot winding and winding switching technology

Design and Control of a New Compound Double-Rotor Electric Machine for Hybrid Propulsion System

Optimal Design of Outer Rotor Interior Permanent Magnet Synchronous Machine with Hybrid Permanent Magnet

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Multi-Objective Optimization Design and Analysis of V-Shape Permanent Magnet Synchronous Motor

Design and Analysis of Modulated Magnetic Pole for Dual Three-Phase Surface-Mounted Permanent Magnet Synchronous Motor

Analysis of a Hybrid Permanent Magnet Variable-Flux Machine for Electric Vehicle Tractions Considering Magnetizing and Demagnetizing Current