Abstract:A new type of 3-DOF manipulator arm was proposed,which was based on (U+UPS)P+ UPS parallel mechanism.Using the idea of sub structure decomposition and superposition,deformation factors of manipulator arm's wrists were divided into 3 main factors:only considering branches' tension/compression deformations,only considering UP branch's torsion deformations,only considering UP branch's bending deformations.Also,3 main factors affecting to stiffness model were established by virtual work principle and structure matrix based on vector loops.Deformation coefficients of each components in the branches were defined according to the structural characteristics of each branches.Then,the stiffness model of each influencing factors was integrated into the whole stiffness model of the manipulator arm by superposition principle.Finally,experimental prototype of the manipulator arm was developed.Using high precision robot calibration system,the stiffness calibration experiments of manipulator arms were done.Experimental results indicate that the deviation between measured position deformations and theoretical position deformations are less than 3 μm,the deviation between measured attitude deformations and theoretical attitude deformations are less than 0.05 °.The deformations of the manipulator arm's experimental prototype are within a reasonable range.

Analysis of Stiffness and Elastic Deformation of a 2(SP+SPR+SPU) Serial–parallel Manipulator

Stiffness and Elastic Deformation of a 3-Leg 5-DOF Parallel Manipulator with One Composite Leg.

Stiffness analysis of overconstrained parallel manipulators

Kinematics/statics analysis of a novel 2SPS + PRRPR parallel manipulator

Stiffness Characterization of A 3-Ppr Planar Parallel Manipulator with Actuation Compliance

Synthesis and Analysis of Kinematics/Statics of a Novel 2SP̱S+SP̱R+SP Parallel Manipulator

Analysis and validation of a planar parallel continuum manipulator with variable Cartesian stiffness

Static Stiffness Modeling and Experiments of Polishing Manipulator Arm

Static Stiffness Analysis of 3-PPSR Parallel Micromanipulator

Kinematics, Statics and Stiffness Analysis of N(4-Sps+Sp) S-Pm

STIFFNESS ANALYSIS ON A WIDE-RANGE FLEXURE HINGE-BASED PARALLEL MANIPULATOR

Stiffness Analysis of a Wire-Driven Parallel Manipulator

Stiffness Modeling and Optimization Analysis of a Novel 6-DOF Collaborative Parallel Manipulator.

Kinematics/Statics of A 4-Dof Over-Constrained Parallel Manipulator with 3 Legs

Stiffness Model of a 3-DOF Parallel Manipulator with Two Additional Legs

Kinematics/statics and workspace analysis of a 3-leg 5-dof parallel manipulator with a upu-type composite active constrained leg

Stiffness and Natural Frequency of a 3-DOF Parallel Manipulator with Consideration of Additional Leg Candidates

Statics and Stiffness Model of Serial-Parallel Manipulator Formed by K Parallel Manipulators Connected in Series

Stiffness Analysis and Comparison of 3-Ppr Planar Parallel Manipulators with Actuation Compliance

Stiffness Modeling Approach for a 3-DOF Parallel Manipulator with Consideration of Nonlinear Joint Stiffness

Kinetostatics Modeling and Analysis of a Spherical Parallel Continuum Manipulator