Abstract:Future communication system requires large bandwidth to achieve high data rate up to multigigabit/ sec, which makes analog-to-digital (ADC) become a key bottleneck for the implementation of digital receivers due to its high complexity and large power consumption. Therefore, monobit receivers for BPSK have been proposed to address this problem. In this work, QPSK modulation is considered for higher data rate. First, the optimal receiver based on monobit ADC with Nyquist sampling is derived, and its corresponding performance in the form of deflection ratio is calculated. Then a suboptimal but more practical monobit receiver is obtained, along with iterative demodulation and small sample removal. The effect of the imbalances between the In-phase (I) and Quadrature-phase (Q) branches, including the amplitude and phase imbalances, is carefully investigated too. To combat the performance loss caused by IQ imbalances, monobit receivers based on double training sequences are proposed. Numerical simulations show that the low-complexity suboptimal receiver suffers only 3dB signal to noise ratio (SNR) loss in AWGN channels and 1dB SNR loss in multipath static channels compared with the matched filter based monobit receiver with full channel state information (CSI). The impact of the phase difference between the transmitter and receiver is presented. It is observed that the performance degradation caused by the amplitude imbalance is negligible. Receivers based on double training sequences can efficiently compensate the performance loss in AWGN channel. Thanks to the diversity offered by the multipath, the effect of imbalances on monobit receivers in fading channels is slight. I

Monobit Digital Receivers: Design, Performance, and Application to Impulse Radio

Monobit Digital Receivers for QPSK Modulation Using Impulse Radio

Performance of Monobit Digital Receivers with Inter-Symbol Interference

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

Monobit Digital Receivers for QPSK: Design, Performance and Impact of IQ Imbalances

Finite-resolution Digital Receiver Design for Impulse Radio Ultra-Wideband Communication

All-digital Sub-sampling Architecture for an Impulse Radio Ultra Wideband Receiver

Performance Analysis of Ir-Uwb 1-Bit Digital Receivers

A 14-Bit 500-Ms/S Sha-Less Pipelined Adc In 65nm Cmos Technology For Wireless Receiver

Joint Viterbi Decoding and Decision Feedback Equalization for Monobit Digital Receivers

Optimal Monobit Digital Receiver for QPSK Modulation with Phase Rotation

Design Of Frequency Domain A/D Conversion Based Uwb Receiver In The Presence Of Quantization Noise

MIMO Networks with One-Bit ADCs: Receiver Design and Communication Strategies

Hybrid Architectures with Few-Bit ADC Receivers: Achievable Rates and Energy-Rate Tradeoffs

Design of A Parallel Low Power Flash A/D Converter for the Sub-Sampling Ir-Uwb Receiver

Finite-resolution receiver performance for IR-UWB target detection

Performance of Digital UWB Receiver Based on A/D Conversion in the Frequency Domain

A nonuniform low sampling rate receiver in UWB communications

A new approach to reduce the resolution requirement of the ADC for high data rate wireless receivers

Design of 4-bit parallel sub-sampling A/D converter for IR-UWB receiver.

Analog Front-End RX Design for UWB Impulse Radio in 90nm CMOS.