Abstract:Purpose The purpose of this paper is to discuss the asymptotic models of different parts with a pitting fault in rolling bearings. Design/methodology/approach For rolling bearings with a pitting fault, the displacement deviation between raceways and rolling elements is usually considered to vary instantaneously. However, the deviation should change gradually. Based on this shortcoming, the variation rule and calculation method of the displacement deviation are explored. Asymptotic models of different parts with a pitting fault are discussed, respectively. Besides, rolling bearing systems have prominent fractional characteristics unconsidered in the traditional models. Therefore, fractional calculus is introduced into the modeling of rolling bearings. New dynamic asymptotic models of different parts with a pitting fault are proposed based on fractional damping. The numerical simulation is performed based on the proposed model, and the dynamic characteristics are analyzed through the bifurcation diagrams, trajectory diagrams and frequency spectrograms. Findings Compared with the model based on integral calculus, the proposed model can better reflect the periodic characteristics and fault characteristics of rolling bearings. Finally, the proposed model is verified by the experiment. The dynamic characteristics of rolling bearings at different rotating speeds are analyzed. The experimental results are consistent with the simulation results. Therefore, the proposed model is effective. Originality/value (1) The above models are idealized, i.e. the local pitting fault is treated as a rectangle. When a component comes into contact with the fault, the displacement deviation between the component and the fault component immediately releases if the component enters the fault area and restores if the component leaves. However, the displacement deviation should change gradually. Only when the component touches the fault bottom, the displacement deviation reaches the maximum. (2) Due to the material's memory and fluid viscoelasticity, rolling bearing systems exhibit significant fractional characteristics. However, the above models are all proposed based on integral calculus. Integral calculus has some local characteristics and is not suitable for describing historical dependent processes. Fractional calculus can better describe the essential characteristics of the system.

A New Statistical Model for Rolling Element Bearing Fault Signals Based on Alpha-Stable Distribution

Gear Fault Signal Modeling and Detection Based on Alpha Stable Distribution

The Bearing Health Condition Assessment Method Based on Alpha-Stable Probability Distribution Model

Model for dynamic characteristics produced by inner race local defect in ball bearing system and its simulation

Low-Rank Enforced Fault Feature Extraction of Rolling Bearings in a Complex Noisy Environment: A Perspective of Statistical Modeling of Noises

Rolling element bearing fault diagnosis based on envelope spectrum of fractional lower order covariance

Application of Margenau-Hill Distribution to Fault Identification of Bearing

Dynamic Asymptotic Model of Rolling Bearings with a Pitting Fault Based on Fractional Damping

Vibration Model of Rolling Element Bearings in a Rotor-Bearing System for Fault Diagnosis

Anomaly Detection and Fault Prognosis for Bearings

Nonlinear vibration signatures for localized fault of rolling element bearing in rotor-bearing-casing system

An Intelligent Approach for Bearing Fault Diagnosis Based on Bayesian Networks and Alpha-Stable Distribution

Nonlinear dynamic modeling and vibration analysis for early fault evolution of rolling bearings

Adaptive Stochastic Resonance Method for Early Fault Detection of Rotating Machinery Based on Alpha Stable Distribution

Fault Diagnosis Based on Nonlinear Dynamic Modeling in Rolling Element Bearing Systems

An Improved Exponential Model for Predicting Remaining Useful Life of Rolling Element Bearings

Dynamic Linear Models-Based Time Series Decomposition and Its Application on Bearing Fault Diagnosis

Rolling element bearings fault diagnosis based on physical model identification

Novel Fault Detection Method for Rolling Bearings Based on Improved Variational Modal Decomposition Method

A Rolling Element Bearing Fault Diagnosis Approach Based on Multifractal Theory and Gray Relation Theory

The application of time domain and frequency domain statistical factors on rolling bearing performance degradation assessment