3D Finite Element Simulation on High-speed Dry Hard Turning Process and Experiment Analysis
WANG He-ping,WU Shen-feng,ZHANG Xue-ping
DOI: https://doi.org/10.13952/j.cnki.jofmdr.2011.01.002
2011-01-01
Abstract:A thermo-mechanical three-dimensional finite element model(FEM) is developed based on Abaqus software to simulate the high-speed hard turning process,by PCBN cutting tool with a large tool nose radius.This paper simulates 3D sawtooth chip induced by periodic adiabatic shear,and validates that the chip characteristic line and material flow direction on the chip-tool interface,the chip morphology on the free surface along feed direction and the cutting depth direction,are all well matched with the actual measured chip morphology.The predicted chip morphology,cutting forces,cutting temperature and plastic strain distribution are compared with experimental data to analyze the effect of tool nose radius and lead angle on hard machining hardened bearing steel.It indictes that,the temperature/strain on the chip is relatively higher,and average tangential force increased about 17 N using cutting tool with lager nose radius 0.8 mm,this is consistent with the experimental results.During oblique cutting process,cutting tool with lead angle enables workpiece material deform more severely and cutting temperature relatively larger,the maximum temperature on the chip-tool interface reaches 1 289℃,which is close to the measured average temperature in the cutting area around 1 100℃;Predicted average tangential force is 150 N,and 7%difference with the experimental data.