Abstract:Scanning Electron Microscope (SEM) is an important observational device in scientific research. Over the past decades, scientists have been working on the high temperature deformation measurement and characterization of the critical alloy materials and components in hot sections by in situ observations with SEM. The in situ observations have both important theoretical and high engineering significance in understanding the mechanisms of the microstructure damage evolution of the alloys, understanding their high temperature failure mechanisms, extracting mechanical parameters and improving the accuracy of life prediction methods. However, in situ high temperature measurements in a SEM environment pose major challenges in high efficiency heat source design, establishment of stable high contrast microscopic images, and quantitative measurement of the deformation fields in high temperature environment. New methods and approaches must be therefore developed for measurement of mechanical properties in such harsh environment. In the study presented here, the major difficulties and challenges associated with high temperature experiments implemented in situ SEM are introduced firstly, especially the imaging failure at high temperature. The developments of high temperature in situ SEM technology in recent years are then reviewed, including high temperature in situ test instruments, high temperature imaging technology, and high temperature deformation measurement methods. On this basis, some new research results achieved by our group in the field of creep, fatigue and fracture of nickel based alloy materials at high temperature are introduced, such as the fatigue small and long crack growth behaviors at different temperature as well as in different crystallographic orientations. Nickel based alloy is the critical material for gas turbine and aero-engine due to their excellent creep, fatigue and corrosion resistance at high temperature. Finally, some conclusions of current development in this research field are presented, meanwhile works that need to be further extended in the future are also pointed out.

Development and application of a high-temperature imaging system for in-situ scanning electron microscope

Atomic Investigation on the Facet‐Dependent Melting of Ceramic Nanostructures Via in Situ Electron Irradiation

In-situ High-Temperature Mechanical Property Measurement Technology and Its Application in Scanning Electron Microscope

Design and Application of Variable Temperature Environmental Capsule for Scanning Electron Microscopy in Gases and Liquids at Ambient Conditions

Development of a microfurnace dedicated to in situ scanning electron microscope observation up to 1300 °C. II. Study of the thermal response of samples

In Situ Scanning Electron Microscopy-Based High-Temperature Deformation Measurement of Nickel-Based Single Crystal Superalloy Up to 800°C

In-situ heating-and-electron tomography for materials research: from 3D ( in-situ 2D) to 4D ( in-situ 3D)

Growth and Faceting of Tungsten and Oxides in Scandate Cathode Particles during In Situ Heating in the Scanning Electron Microscope

High-temperature strain measurement using active imaging digital image correlation and infrared radiation heating

In Situ High Temperature Microwave Microscope for Nondestructive Detection of Surface and Sub-Surface Defects.

In Situ Scanning–digital Image Correlation for High-Temperature Deformation Measurement of Nickel-Based Single Crystal Superalloy

A novel nano-scale non-contact temperature measurement technique for crystalline materials

Spatially Resolved Dynamically Reconfigurable Multilevel Control of Thermal Emission

Strain Field Measurements over 3000 °C Using 3D-Digital Image Correlation

Advanced In Situ TEM Microchip with Excellent Temperature Uniformity and High Spatial Resolution

Synchronous Measurement of Temperature and Deformation by an Ultraviolet Imaging System and Monochromatic Pyrometry at Extreme Temperatures

In-Situ SEM Deformation Testing of Ni-Based Superalloy Heated by the Joule Heat

Quantitative Thermal Imaging of Single-Walled Carbon Nanotube Devices by Scanning Joule Expansion Microscopy.

Quantifying Real-Time Sample Temperature Under the Gas Environment in the Transmission Electron Microscope Using a Novel MEMS Heater

In Situ Observation and Measurement of Composites Subjected to Extremely High Temperature.

Development of In-situ Orientation Mapping and Microstructure Observation System for Ferrite/Austenite and Martensitic Transformations in Steel