Abstract:Binder Jetting-Metal Additive Manufacturing (BJ-MAM) is a powder bed-based additive manufacturing technology which deposits liquid binder droplets to join powder particles to form complex shaped structures (i.e., green parts). As the printing process is done around room temperature, BJ-MAM is largely immune to the distortion and cracking issues that can be prevalent in melting based powder bed processes. However, a main issue for BJ-MAM is the part shrinkage and distortion during high-temperature sintering. The densification and deformation behaviors during pressureless sintering of green parts printed by BJ-MAM were studied in this paper. Experimentally, cantilever- and bridge-shaped coupons with varying beam lengths were printed using 316L stainless steel powder; these coupons produced different extents of deformation after sintering. Based on the existing modeling approaches in the powder metallurgy literature, a finite element model was developed incorporating an elastic-viscoplastic constitutive equation for computing both uniaxial equivalent creep strain and volumetric swelling strain. Two methods, a viscosity based and a power-law creep based, were further evaluated for calculating the uniaxial equivalent creep strain. Material property data used in the constitutive equation such as viscosity and creep parameters were collected from the literature, critically reviewed, and then inputted into the model. Other salient features of the model included thermal-mechanical property data that were dependent on both relative density and temperature as well as frictional contact between the part surface and the furnace wall under gravitational load. The calculated quantities such as shrinkage, final relative density, and deformed shapes were compared with the respective experimental data across different part geometries.

Non-heat source forming technology of binder jetting metal powder and its post-treatment process

State of the art of metal powder bonded binder jetting printing technology

Binder jetting: A review of process, materials, and methods

Metal Binder Jetting Additive Manufacturing: A Literature Review

Binder jet 3D printing—Process parameters, materials, properties, modeling, and challenges

Powder Optimization for Enhanced Printing and Sintering of Porous Tungsten in Binder Jet Printing

Binder jetting additive manufacturing of 316L stainless-steel green parts with high strength and low binder content: Binder preparation and process optimization

Process development for green part printing using binder jetting additive manufacturing

Influence of Different Powder Conditioning Strategies on Metal Binder Jetting with Ti-6Al-4V

Powder reusability in Metal Binder Jetting

Study on powder particle behavior in powder spreading with discrete element method and its critical implications for binder jetting additive manufacturing processes

Simulation of Binder Jetting and Analysis of Magnesium Alloy Bonding Mechanism

Towards Binder Jetting and Sintering of AZ91 Magnesium Powder

A thermal-initiated monomer binder enhancing green strength with low binder saturation for binder jetting additive manufacturing of cemented carbide

Process parameters optimization for improving surface quality and manufacturing accuracy of binder jetting additive manufacturing process

High-Speed X-Ray Imaging of Droplet-Powder Interaction in Binder Jet Additive Manufacturing

Effect of feedstock bimodal powder design and cold isostatic pressing on the mechanical behavior of binder jetting additive manufactured Inconel 718 superalloy

Numerical simulation and experimental measurement of pressureless sintering of stainless steel part printed by Binder Jetting Additive Manufacturing

A review of binder jet process parameters; powder, binder, printing and sintering condition

Optimization of Binder Jetting Using Taguchi Method

Binder jetting of ceramics: Powders, binders, printing parameters, equipment, and post-treatment