Structured nanoporous Cu/ZnO catalysts for on-board methanol steam reforming prepared by laser powder bed fusion and dealloying

Chuandong Li,XinQi Yao,Ruhang Zhang,HongXiang Zheng,Shuaishuai Yuan,Xinhai Yu,Bo Li,Minghui Zhu,Shan-Tung Tu
DOI: https://doi.org/10.1016/j.cej.2024.150467
IF: 15.1
2024-05-01
Chemical Engineering Journal
Abstract:The development of efficient structural catalysts and reactors (SCRs) for on-board methanol steam reforming (MSR) has long been a focal point. Traditional MSR SCRs exhibit problems such as poor heat transfer, low catalyst loading, and coating delamination. In this study, novel three-dimensional graded nanoporous Cu/ZnO (3DNP-Cu/ZnO) SCRs were prepared via metal 3D printing technology and dealloying. For 3DNP-Cu/ZnO SCRs activated with MeOH/H2O steam, both the interfacial area of Cu-ZnO and the Cu+/(Cu0 + Cu+) molar ratio were greater than those of catalysts activated with H2/N2 mixtures. The experimental results showed that a 3DNP-Cu/ZnO SCR activated with MeOH/H2O for 20 min exhibited a high methanol conversion rate of 98.3 % with a CO selectivity of 0.86 % (with a reaction temperature of 280 °C, a water-to-alcohol molar ratio of 1.3 and a weight hourly space velocity of 30 h−1). The superior catalytic activity was attributed to the high Cu+/(Cu++Cu0) ratio, which enabled the generation of *CHOO during the MSR reaction. Additionally, the 3DNP-Cu/ZnO SCRs demonstrated low pressure drops and high mechanical strengths. Computational fluid dynamics simulations showed that the gyroid lattice-structured catalyst achieved a high H2 concentration due to its high mass and heat transfer. 3DNP-Cu/ZnO SCRs provide a new strategy for the preparation of MSR SCRs with broad application prospects.
engineering, chemical, environmental
What problem does this paper attempt to address?