Abstract:A passive and active neutron measurement system has been developed within the MICADO H2020 project, to estimate the nuclear material mass inside legacy waste drums of low and intermediate radioactivity levels. Monte-Carlo simulations were performed to design a transportable neutron system allowing both passive neutron coincidence counting and active interrogation with the Differential Die-away Technique. However, the calibration coefficients representing the signal of interest (due to nuclear material) in these two measurement modes may vary by a large amount depending on the properties of the matrix of the nuclear waste drum. Therefore, this paper investigates matrix effects based on 104 Monte-Carlo calculations with different waste drums, based on Taguchi experimental design with a range of densities, material compositions, filling levels and nuclear material masses. A matrix correction method is studied using machine learning algorithms. The matrix effect on the neutron signal is deduced from the signal of internal neutron monitors located inside the measurement cavity, and from a transmission measurement with an AmBe neutron source. Those quantities can be assessed experimentally and are used as explanatory variables for the definition of a predictive model of the simulated calibration coefficient, either in passive or in active mode. A multi-linear regression model of the calibration coefficient based on ordinary least square (OLS) is built and compared to the Random Forest (RF) machine-learning algorithm, and to the multi-layer perceptron artificial neural network (MLP). In passive neutron coincidence counting, the residual error of the regression is lower for the MLP and RF than for OLS. The agreement between the predicted calibration coefficients of four mock-up drums used as test is better than 17% and 3%, respectively, with the MLP and RF methods, while three predictions are out of the 95% confidence level range with OLS. In active neutron interrogation, similar conclusions are drawn. The prediction of the calibration coefficient for the four mock-up drums is better than 12%, 35% and 72% for the respective MLP, RF and OLS methods. In conclusion, MLP and RF regression model demonstrates more accurate results of the quantities of interest than the traditional OLS method. The future steps will focus on matrix heterogeneities, experimental validation, improving our models and testing new regression approaches.

First steps towards productionizing probabilistic radwaste characterization

Improving Bayesian radiological profiling of waste drums using Dirichlet priors, Gaussian process priors, and hierarchical modeling

Application of Machine Learning to MICADO passive and active neutron measurement system for the characterization of radioactive waste drums

A novel approach to the localization and the estimate of radioactivity in contaminated waste packages via imaging techniques

Probabilistic biosphere modeling for the long-term safety assessment of geological disposal facilities for radioactive waste using first- and second-order Monte Carlo simulation

Towards inferring reactor operations from high-level waste

Gaussian Processes for Surrogate Modeling of Discharged Fuel Nuclide Compositions

A Comparison Between Bayesian and Ordinary Kriging Based on Validation Criteria: Application to Radiological Characterisation

A Method to Obtain Radioactivity of Non-Γ Nuclides by 60co Based on Monte Carlo Simulations

Matrix effect correction in active neutron interrogation for residual fissile mass assessment in radioactive waste drums

Uncertainty analysis of in-situ gamma spectrometry measurements of air cleaning filter cartridges and 200 L drums by a HPGe detector

Assessing the Feasibility of Interrogating Nuclear Waste Storage Silos using Cosmic-ray Muons

An operational approach for accurate 177Lu and 177mLu activity quantifications to comply with the environmental release criteria: the role of GEANT4 for efficiency curve and True Coincidence Summing effect estimation

Advanced methodology for uncertainty propagation in computer experiments with large number of inputs

Radiological characterization of high-energy proton Tantalum targets from CERN-ISOLDE Facility

Uncertainty and sensitivity analysis of radionuclide migration through the engineered barriers of deep geological repository: Case of RBMK-1500 SNF

Validation of a free release measurement facility on a decommissioning site

The worldwide NORM production and a fully automated gamma-ray spectrometer for their characterization

Performance assessment and further optimization of the activation based criticality dosimetry system at the Belgian nuclear research centre SCK CEN

Polynomial chaos expansion for global sensitivity analysis applied to a model of radionuclide migration in a randomly heterogeneous aquifer