Abstract:Cuprous oxide (Cu2O), as one of the traditional photocatalytic antifouling agents, has its own defects for practical applications such as rapid recombination of carriers, serious photocorrosion (Cu2O changing into CuO) and explosive release of cuprous ions. Herein, a novel ternary interfacial heterojunction (Cu2O/C/CCN) was prepared by carbon doping of g-C3N4 followed by in-situ carbon film covering and Cu2O loading. Compared with pure Cu2O and Cu2O/g-C3N4, Cu2O/C/CCN presented more powerful broad-spectrum and long-term photocatalytic antibacterial properties against S. aureus and P. aeruginosa, and the antibacterial rate remained at approximately 94.28% and 90.54%, respectively, even after storage 30 days. The high antibacterial rate of the Cu2O/C/CCN can be attributed to the high photocatalytic performance and stable and continuous release of cuprous ions. The carbon doping of g-C3N4 could adjust its band gap and promote more efficient photoexcited carrier generation and transfer by the formation of delocalized large π bonds like “electron bridge” as the first charge transfer channel. The existence of carbon film between g-C3N4 and Cu2O can build the second highly efficient charge transfer channel for the separation of photoexcited carriers by forming a Z-scheme interfacial heterojunction. DFT calculation and fluorescence spectrum results showed that more active electrons on CCN tend to transfer to Cu2O through the two nonradiative decay pathways. The highly efficient carrier transport and separation can also greatly reduce the 15.3% generation of CuO compared to Cu2O/g-C3N4. The more negative reduction potential further promoted the ROS generation for sterilization. In addition, the loading of Cu2O on 2D C/CCN can reduce the contact area between Cu2O and solution and then slow the release rate of cuprous ions by 75% compared to Cu2O. Therefore, Cu2O/C/CCN has great potential for practical antifouling applications.

Photocorrosion behavior of Cu2O nanowires during photoelectrochemical CO2 reduction

Understanding Oxidation State of Cu-based Catalysts for Electrocatalytic CO2 Reduction

Photoelectrocatalytic Reduction of CO2 to CO via Cu2O/C/PTFE Nanowires Photocathodes

Study on photoelectrochemical CO2 reduction over Cu2O

Insights into the Development of Cu-based Photocathodes for Carbon Dioxide (CO2) Conversion

Asymmetric Cu-N sites on copper oxide photocathode for photoelectrochemical CO2 reduction towards C2 products

Hydrophobic surface efficiently boosting Cu2O nanowires photoelectrochemical CO2 reduction activity

Improvement of the Photoelectrochemical Stability of Cu2O Photocathode by PhCCCu Grafting

Cu2O/2D COFs Core/Shell Nanocubes with Antiphotocorrosion Ability for Efficient Evolution

Cu 2 O/2D COFs Core/Shell Nanocubes with Antiphotocorrosion Ability for Efficient Photocatalytic Hydrogen Evolution.

Metal-Organic Framework Coating Enhances the Performance of Cu2O in Photoelectrochemical CO2 Reduction.

Superaerophilic Copper Nanowires for Efficient and Switchable CO2 Electroreduction.

Manipulating Cu Nanoparticle Surface Oxidation States Tunes Catalytic Selectivity Toward CH4 or C2+ Products in CO2 Electroreduction

Cu2O nanocubes with mixed oxidation-state facets for (photo)catalytic hydrogenation of carbon dioxide

Study on nanoporous CuBi2O4 photocathode coated with TiO2 overlayer for photoelectrochemical CO2 reduction

Cu2O photocathodes prepared by thermal reduction of CuO: Influence of O 2 concentration on photocurrent stability

Investigation and mitigation of degradation mechanisms in Cu2O photoelectrodes for CO2 reduction to ethylene

Cu2O as an emerging photocathode for solar water splitting - A status review

Creating dual charge transfer channels to collaborative enhance the photocatalytic bacteriostatic efficiency and photocorrosion resistance of Cu2O based nanocomposites

Cu2O/CuO heterojunction formed by thermal oxidation and decorated with Pt co-catalyst as an efficient photocathode for photoelectrochemical water splitting

Stable Aqueous Photoelectrochemical CO2 Reduction by a Cu2O Dark Cathode with Improved Selectivity for Carbonaceous Products