Abstract:Excessive burning of fossil fuels for energy production has led to an exponential increase in CO 2 concentrations in the atmosphere, which is the core of universal problems such as global warming and climate change. One of the new approaches to reducing CO 2 emissions is to think of CO 2 as a useful raw material and convert this compound into useful products. Moreover, electrocatalytic carbon dioxide reduction (eCO 2 R) can be conveniently utilized to establish a zero-emission carbon cycle and utilize this CO 2 for energy-dense fuels and other chemical raw materials [1]. However, exploring novel catalysts is the ultimate need of the hour for an effective and efficient eCO 2 R. Heterogeneous single-atom catalysts (SAC) containing isolated metal species on an atomic level are gaining the increasing attention of the scientific community owing to their high metal utilization sites and superior catalytic properties[2]. The SACs are put into the full effect of catalysis by scattering it over conductive support. Therefore, in this work, the copper SACs are supported over a unique porphyrin-based graphdiyne (SAC-PG) with a π-conjugated structure (Figure 1). Graphdiyne possesses two acetylenic linkages between the aromatic rings and is responsible for not only displaying exceptional electronic conductivity but when coupled with the metalloporphyrin network provides numerous active sites for catalysis[3]. This SAC-PG analogue is achieved by a Glaser-Hay coupling reaction on Cu foam or foil. Moreover, SEM analysis is performed in combination with SEM-EDX and elemental mapping to investigate the morphology of the fabricated catalyst (Figure 2). In addition, this unique copper-based SAC-PG is evaluated as a catalyst for eCO 2 R in a customized H-cell with 0.1M/0.5M KHCO 3 as an electrolyte and Pt as a counter electrode. Nafion 117 proton exchange membrane is used for separation between the cathodic and anodic compartments while an Ag/AgCl (3M KCl) was used as a reference electrode. Under these eCO 2 R conditions, the copper SAC-PG catalyst displayed extremely high current densities (32 – 75 mA/cm 2 ) over a range of voltages (1.0-1.2 V vs RHE) and acceptable faradaic efficiencies for the carbon products (with maximum FE over 60% in total for all carbon products). In conclusion, a 2D metal covalent organic framework containing a repeating unit of Cu-porphyrin linked by butadiyne linkages was established. This unique structure showed effective CO 2 R catalysis due to its nanoporous structure, high electronic conductivity, and abundant metal cites utilization. Further optimization and constriction of these easily adjustable catalysts open up various possibilities of further exploration in the field of eCO 2 R. Acknowledgement : The author Zubair Masaud acknowledges support from the Norwegian Micro- and Nano-Fabrication Facility (NorFab, No. 245963/F50) The author Hao Huang acknowledges Marie Skłodowska-Curie Actions individual fellowship CarbonChem 101024758. References [1] I. Ganesh, “Electrochemical conversion of carbon dioxide into renewable fuel chemicals - The role of nanomaterials and the commercialization,” Renew. Sustain. Energy Rev. , vol. 59, pp. 1269–1297, 2016, doi: 10.1016/j.rser.2016.01.026. [2] X. Yang, A. Wang, B. Qiao, and J. U. N. Li, “Single-Atom Catalysts : A New Frontier,” vol. 46, no. 8, 2013. [3] C. Huang et al. , “Progress in Research into 2D Graphdiyne-Based Materials,” Chem. Rev. , vol. 118, no. 16, pp. 7744–7803, 2018, doi: 10.1021/acs.chemrev.8b00288. Figure 1

Non‐Aqueous Electrochemical CO2 Reduction to Multivariate C2‐Products Over Single Atom Catalyst at Current Density up to 100 mA cm−2

Single‐Atom Electrocatalysts from Multivariate Metal–Organic Frameworks for Highly Selective Reduction of CO2 at Low Pressures

Single‐Atom Electrocatalysts from Multivariate MOFs for Highly Selective Reduction of CO2 at Low Pressures

Metal-organic Framework Derived Single-Atom Catalysts for Electrochemical CO2 Reduction

Development of Mn/Cu Bi-metallic MOF for electrochemical CO2 reduction into valuable products

A 2D Porous Cu3N Catalyst for Efficient CO Electroreduction to Multicarbon Products at an Ampere Level Current Density

Insights on forming N,O-coordinated Cu single-atom catalysts for electrochemical reduction CO2 to methane

Rational Fabrication of Low‐Coordinate Single‐Atom Ni Electrocatalysts by MOFs for Highly Selective CO2 Reduction

Molecular and single-atom catalysts based on earth-abundant transition metals for the electroreduction of CO2 to C1

Exploring Electrocatalytic CO2 Reduction Over Materials Derived from Cu‐Based Metal‐Organic Frameworks

Ligand-Engineered Metal–Organic Frameworks for Electrochemical Reduction of Carbon Dioxide to Carbon Monoxide

CuC(O) Interfaces Deliver Remarkable Selectivity and Stability for CO2 Reduction to C2+ Products at Industrial Current Density of 500 mA cm−2

Single Atom Supported on Mos2 As Efficient Electrocatalysts for the Co2 Reduction Reaction: A Dft Study

Metal-Organic Frameworks-Derived Single Atom Catalysts for Electrocatalytic Reduction of Carbon Dioxide to C1 Products

Atomically Dispersed Manganese on Carbon Substrate for Aqueous and Aprotic CO2 Electrochemical Reduction.

Fabrication of Cu-Single Atom Catalyst Supported on Unique 2D Graphdiyne Analogue-Based Porphyrin Metal Covalent Organic Frameworks for Carbon Dioxide Reduction Application

Selective CO2 Electroreduction to Multi-Carbon Products on Organic-Functionalized CuO Nanoparticles by Local Micro-Environment Modulation

Synergistic electroreduction of carbon dioxide to carbon monoxide on bimetallic layered conjugated metal-organic frameworks

Efficient CO2 Electroreduction to Multicarbon Products at Cusio3/Cuo Derived Interfaces In Ordered Pores

Ligand Engineered Metal−Organic Frameworks for Electrochemical Reduction of Carbon Dioxide to Carbon Monoxide

CO2 electroreduction to multicarbon products in strongly acidic electrolyte via synergistically modulating the local microenvironment