Abstract:O3-type NaCrO2 is attracting increasing attention as potential cathode material for sodium-ion batteries (SIBs). Bare NaCrO2 is usually synthesized by a solid-state reaction and suffers from serious capacity decay and poor power capability. Modification by coating is an effective method to improve the electrochemical properties, but it inevitably reduces the energy density. To avoid the decrease of energy density and optimize the electrochemical performance, a specific route, i.e., a freeze-drying-assisted sol–gel method, has been adopted to synthesize bare NaCrO2 in this work. Three-phase coexistence during charging is confirmed for the first time, which contributes to delaying the disappearance of the O3 phase and then improving the structural reversibility, resulting in superior cycle stability (∼50% capacity retention after 3000 cycles at 5C). Meanwhile, as-synthesized NaCrO2 delivers an outstanding rate capability (82.1 mAh g–1 at 50C), which is attributed to the fast Na+ diffusivity and high electronic conductivity proved by density functional theory (DFT) calculations. It is worth mentioning that NaCrO2 also exhibits excellent electrochemical properties when used as a cathode for potassium-ion batteries (PIBs). This work provides new perspectives on the structural evolution of NaCrO2, and the results are expected to contribute to the development of SIBs and PIBs.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c04997?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c04997</a>.Performance comparison chart with reported literature reports; charge–discharge curves at different rates; calculated Ip–ν0.5 patterns; Na+ diffusion coefficients; EIS parameters; and ex situ XRD (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c04997/suppl_file/am1c04997_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Cation-Disordered O3-Na 0.8 Ni 0.6 Sb 0.4 O 2 Cathode for High-Voltage Sodium-Ion Batteries

La-doped O3-type Layered Oxide Cathode with Enhanced Cycle Stability for Sodium-Ion Batteries

A High-Rate, Durable Cathode for Sodium-Ion Batteries: Sb-Doped O3-Type Ni/Mn-Based Layered Oxides.

Ti‐Substituted NaNi0.5Mn0.5‐xTixO2 Cathodes with Reversible O3−P3 Phase Transition for High‐Performance Sodium‐Ion Batteries

Regulating Phase Transition and Oxygen Redox to Achieve Stable High‐Voltage O3‐Type Cathode Materials for Sodium‐Ion Batteries

A P2/O3 biphasic cathode material with highly reversibility synthesized by Sn-substitution for Na-ion batteries

O3-Type Na 2/3 Ni 1/3 Ti 2/3 O 2 Layered Oxide as a Stable and High-Rate Anode Material for Sodium Storage

Sb-Doped O3-NaNi0.3Fe0.2Mn0.5O2 Cathode with Improved Cyclic Stability for Sodium-Ion Batteries

Synthesis, structure, and electrochemical properties of O′3-type monoclinic NaNi0.8Co0.15Al0.05O2 cathode materials for sodium-ion batteries

Depressed P3-O3' phase transitions in O3-type layered cathode for advanced sodium-ion batteries

Sodium Storage Property and Mechanism of NaCr1/4Fe1/4Ni1/4Ti1/4O2 Cathode at Various Cut-off Voltages

A New High-Performance O3-NaNi0.3Fe0.2Mn0.5O2 Cathode Material for Sodium-Ion Batteries

Reaching the Initial Coulombic Efficiency and Structural Stability Limit of P2/O3 Biphasic Layered Cathode for Sodium-Ion Batteries

Deciphering the Formation Process and Electrochemical Behavior of Novel P2/O3 Biphasic Layered Cathode with Long Cycle Life for Sodium-Ion Batteries

Rational Design of a P2-Type Spherical Layered Oxide Cathode for High-Performance Sodium-Ion Batteries

A Stable Layered Oxide Cathode Material for High‐Performance Sodium‐Ion Battery

A High‐Entropy Intergrowth Layered‐Oxide Cathode with Enhanced Stability for Sodium‐Ion Batteries

O3-Type NaCrO 2 as a Superior Cathode Material for Sodium/Potassium-Ion Batteries Ensured by High Structural Reversibility

P2-Type Layered Oxide Cathode with Honeycomb-Ordered Superstructure for Sodium-Ion Batteries

Synthesis and Electrochemical Investigation of O3-Type High-nickel NCM Cathodes for Sodium-ion Batteries