Comprehensive utilization and safe disposal of hazardous arsenic-alkali slag by the combination of beneficiation and metallurgy

Jia Tian,Wei Sun,Xingfei Zhang,Haisheng Han,Zhiyuan Yu,Tong Yue,Li Wang,Yue Yang,Honghu Tang,Erping Li
DOI: https://doi.org/10.1016/j.jclepro.2021.126381
IF: 11.1
2021-05-01
Journal of Cleaner Production
Abstract:<p>The accumulation of hazardous arsenic-alkali slag poses a great threat to the environment and human health due to the high content of soluble sodium arsenate. In this paper, a novel process scheme is proposed for the comprehensive utilization and safe disposal of arsenic-alkali slag by the combination of beneficiation and metallurgy. The new technology is novel since every procedure of high arsenic content is run at room temperature, which guarantees good occupational health. The valuable alkali and antimony were recovered efficiently without any secondary pollution. The separation of arsenic and alkali is the most difficult and critical section of the process, where magnesium salt and ammonium salt were added to the arsenic alkali solution in certain manner to selectively precipitate arsenic in the form of MgNH<sub>4</sub>AsO<sub>4</sub>·6H<sub>2</sub>O (magnesium ammonium arsenate) and Mg<sub>3</sub>(AsO<sub>4</sub>)<sub>2</sub>·8H<sub>2</sub>O (magnesium arsenate). By controlling the addition of ammonium salt and magnesium salt, arsenic slag with high arsenic content, good sedimentation performance, and high crystallinity was produced. The arsenic slag can be stored by rigid landfill for the future development. The whole process is relatively simple and safer than existing approaches, providing an alternative solution for the treatment of hazardous arsenic-alkali slag.</p>
environmental sciences,green & sustainable science & technology,engineering, environmental
What problem does this paper attempt to address?
The main problem that this paper attempts to solve is the safe disposal and comprehensive utilization of arsenic - alkali slag. Specifically, the paper proposes a new process plan that combines beneficiation and metallurgy technologies, aiming to achieve the following goals: 1. **Safe precipitation of substances with high arsenic content**: By adding magnesium salts and ammonium salts to the arsenic - alkali solution under specific conditions, high - purity ammonium magnesium arsenate (MgNH\(_4\)AsO\(_4\)·6H\(_2\)O) and magnesium arsenate (Mg\(_3\)(AsO\(_4\))\(_2\)·8H\(_2\)O) are selectively precipitated, thus effectively separating arsenic and alkali. 2. **Recovery of valuable components**: Efficiently recover alkali and antimony in arsenic - alkali slag, avoid secondary pollution, and at the same time reduce the burden of subsequent water treatment. 3. **Simplify the treatment process**: The whole process is carried out at room temperature, ensuring good occupational health conditions, and the operation is relatively simple and low - cost. 4. **Meet landfill standards**: The treated arsenic slag has good sedimentation performance and high crystallinity and can be safely landfilled in a rigid manner, leaving room for future development. Through experimental research, the paper verifies the effectiveness and feasibility of this new process, providing a new solution for the safe disposal and resource utilization of arsenic - alkali slag.