Pressure Change Of Fixed Rotational Deformities In The Femur In Human Cadaver Knees-A Biomechanical Study
Peizhi Yuwen,Hongzhi Lv,Yanbin Zhu,Wenli Chang,Ning Wei,Jialiang Guo,Haicheng Wang,Kai Ding,Yingze Zhang,Wei Chen
DOI: https://doi.org/10.21203/rs.3.rs-122625/v1
2020-12-10
Abstract:Abstract Objective: To reveal the contact pressure change on tibial plateau in malalignment femur. Methods: Fourteen adult cadaver were selected, after autopsy, 14 cadaveric knee were established and fixed at neutral position (0°, anatomically reduced), 5°, 10°, 15° of external rotation, and 5°, 10°, 15° of internal rotation. Connect the rotatory fixation model on the biomechanical machine and apply a vertical load to 400N. The contact pressure on medial and lateral tibial plateau was quantitatively measured using ultra-low-pressure sensitive film technology. FPD-305E density meter and FPD-306E pressure converter were used to read relative pressure value. Data were analyzed using SPSS software. Results: The medial group show a significant difference on tibial plateau ( F =92.114, P <0.01), further test showed statistically significant differences of pairwise comparisons between 0°, 5°, 10°, 15° internal rotation deformity ( P <0.05). There is no significant difference in lateral group ( c 2 =9.967, P <0.01). The medial contact pressure is 0.940±0.177 MPa and the lateral is 1.008±0.219 MPa at neutral position, no statistically significant was found, so is 5° of internal rotational deformity. But the medial contact pressure are all higher than the lateral side at 5°, 10°, 15° of external rotation, and 10°, 15° of internal rotation. Conclusion: Obvious contact pressure changes on tibial plateau were observed in rotatory deformity femur, which is closely related to the occurrence of knee osteoarthritis. Doctors should detect rotational deformity as much as possible during operation and perform anatomical reduction, for patients with residual rotational deformities, indication of osteotomy should not be too broad.