Topology optimization in cooling moving heat sources for enhanced precision of machine tool feed drive systems
Shuang Zeng,Jialan Liu,Chi Ma
DOI: https://doi.org/10.1016/j.ijthermalsci.2024.109065
IF: 4.779
2024-04-18
International Journal of Thermal Sciences
Abstract:The machining accuracy of the whole machine tool is significantly reduced by the thermal error of the feed drive system, which accounts for more than 50 % of the total error of the machine tool. Specifically, the heat generation, particularly within the feed drive system, emerges as a significant challenge, impacting the system's positioning accuracy and repetitive positioning accuracy. To reduce the thermal effect, cooling systems are commonly installed to suppress temperature rise and improve thermal accuracy currently. But the design of the cooling device with commonly-used spiral and serpentine cooling channels relies on empirical methods, often resulting in significant drawbacks such as substantial pressure losses and uneven temperature distribution. Moreover, the nut and slider in machine tool feed drive system act as moving heat sources, resulting in an uneven temperature field and thermal deformation in the axial direction of screw shaft. To confront the aforementioned complexities, the novel strategy of cooling moving heat sources such as nuts and sliders is proposed for the first time. Then a topology optimization model, which is more closely aligned with the specific practical applications, is proposed. Specifically, the control equations of the topology optimization model are rendered dimensionless and meticulously adjusted to account for the surface heat dissipation of the cooling devices, with a heat dissipation term incorporated into the control equations. Comparison of the topology optimization results at various iteration steps of the objective function is conducted to identify the most optimal proportional coefficient. Extensive numerical and experimental verifications are conducted, comparing traditional and topology-optimized flow channels in terms of temperature and pressure performances. The pressure loss in the topology-optimized channel is significantly lower compared to that of the S-shaped cooling channel, and the pressure loss is reduced by 28.6 %. The heat dissipation performance is significantly better than that of the L-shaped flow channel, and the average surface temperature is reduced by 27.7 %. The experiment results confirm the superiority of the topology-optimized cooling channels in efficiently controlling the temperature and maintaining pressure balance. By implementing the designed cooling plate and water jacket, the axial thermal expansion of the screw shaft is curtailed by approximately 10 %, leading to a reduction in the feed drive system's positioning error by over 77 %.
engineering, mechanical,thermodynamics