Effect of Feeding Rate on Pollutant Emission of Biomass Pellet Burner
YANG Guofeng,YU Youfang,SHENG Kuichuan
DOI: https://doi.org/10.3785/j.issn.1008-9209.2017.01.101
2017-01-01
Abstract:Biomass pellets, prepared from wood particles, straws, and other agricultural and forestry residues, possessed the advantages of higher energy density, convenient transportation and storage, and reduced fossil energy consumption and greenhouse gas emissions. They have been widely used in industrial boilers, agricultural greenhouses and household heatingunits. Currently, the efficient measurement and control of pollutant emission during biomass pellet combustion become increasingly important and attract more and more public awareness. Feeding rate is one of the critical factors that determine the combustion status and pollutant emissions. Previous researches mainly focused on the effect of feeding rate on carbon oxide (CO) emission, while the impact on nitrogen oxides (NOx) emission was seldomly reported. The new China National Emission Regulation (NER) issued in early 2012 requires that NOx emission must be controlled below 100 mg/m3. The objective of this study was to investigate the effect of feeding rate on the emission and variation of CO and NOx based on a 5G-20/85-0.23 biomass pellet burner platform. Average feeding rates of 6.9, 6.2, 5.5, 5.0 and 4.5 kg/h were employed, corresponding to the set of working and pausing time in the feeding mechanism at 2 s/13 s, 2 s/15 s, 2 s/17 s, 2 s/19 s, and 2 s/21 s, respectively (labelled as 2/13,2/15,2/17,2/19,2/21). Results showed that CO emission was reduced with the feeding rate decreased from 6.9 to 5.0 kg/h, and the lowest COconcentration of 66 mg/Nm3 was achieved at the feeding rate of 5.0 kg/h. When the feeding rate was further reduced to 4.5 kg/h, the highest CO concentration of 205 mg/Nm3 was obtained. Overall, the CO emission first decreased and then increased for the feeding rate range of 6.9 to 4.5 kg/h. With the decreasing of feeding rate, oxygen (O2) concentration increased first and then decreased. Maximal O2 concentration of 16% was achieved with the feeding mechanism of 2/19. Fluctuation of CO concentration with time reflects the combustion quality and consistency inside the furnace, and minimal fluctuation is preferred. The highest fluctuation of CO concentration appeared when the feeding mechanism was set at 2/13, and a fluctuation peak was noticed at 80 s, which was probably caused by the pellet accumulation in the furnace and incomplete combustion in generating more CO. Overall, the fluctuation period was in good agreement with the feeding period. The effect of feeding rate on NO, NO2, and NOx concentrations was similar to that of CO, with the lowest NOx of 8.8 mg/Nm3 obtained at feeding rate of 5.0 kg/h and highest NOx of 78 mg/Nm3 obtained at 6.9 kg/h. The furnace temperature at lower position reached 758 ℃ at the optimal feeding rate. When the feeding rate was 4.5 kg/h, the temperature was only 375 ℃. The periodical fluctuation of NOx is not as obvious as CO. With the feeding mechanisms of 2/19 and 2/17, very minor fluctuations of NOx with time were observed. The NOx fluctuations were relatively larger with 2/15 and 2/13 feeding mechanisms. In summary, the concentrations of CO and NOx in the emission are significantly affected by biomass pellet feeding rate. Minimal CO and NOx emissions are achieved when the feeding mechanism is set at 2/19. Periodical fluctuation of NOx with time is less obvious compared with CO. These results provide both practical data and theoretical basis for the optimization of feeding rate for biomass pellet burners.