Abstract:Waterjet-assisted laser drilling technology facilitates the fabrication of high-quality micro-holes by utilizing the collaborative benefits of waterjets and lasers. In this study, the coaxial waterjet-assisted laser drilling (CWALD) technique was employed to improve the properties of micro-holes during femtosecond laser drilling. Based on computational fluid dynamics (CFD) simulations, the stability of the waterjet was initially verified by optimizing the structure of the watercourse and nozzle shape in the CWALD device. Furthermore, a comparative experiment between laser direct drilling (LDD) and CWALD revealed that while CWALD can produce well-rounded micro-holes with a high aspect ratio, it exhibits lower efficiency and results in a larger heat-affected zone (HAZ). To address these drawbacks associated with CWALD, a two-step coaxial waterjet-assisted composite laser drilling (TS-CWALD) method was proposed. TS-CWALD involves applying CWALD for secondary modification of micro-hole shape following LDD with punching. This modification process is pivotal for enhancing drilling accuracy but requires consideration of multiple parameters. For this purpose, regression models were established for the inlet diameter, outlet diameter, and taper; response surface methodology was then employed to optimize these parameters. Subsequently, interactive effects analysis was conducted on different responses based on laser pulse energy, frequency, modification speed, and number of modification cycles. The adequacy of the developed models was subsequently verified using analysis of variance methods. Finally, the successful fabrication of a film hole with an inlet diameter of 205 μm and an outlet diameter of 200 μm, featuring a taper of only 0.2°, was achieved ultimately through meticulous parameter optimization. Furthermore, the micro-hole retained a minimal HAZ. The optimized parameters encompassed a pulse energy of 20.6 μJ, frequency of 127 kHz, modification speed of 3 mm/s, and shape modification carried out over 335 cycles.

In Situ Laser-Assisted Micro-imprinting Process for Microscale Tapered Hole Forming

Microfabrication Assisted by Laser-Trapped Microparticle Tools

Laser drilling of micro-holes with controllable taper using 355 nm nanosecond laser

Process in laser drilling of deep microholes without taper on metal materials

Femtosecond laser processing of controlled tapered micro-holes based on dynamic control of relative attitude

Research on Microhole Processing Technology Based on the Femtosecond-Laser Spiral Trepanning Method

Study of deformation behavior of plastic metal materials during laser-assisted micro-imprinting formings

Mass Fabrication of Microholes in Aviation Kerosene Filters Using the Back-water-assisted Picosecond Laser Drilling Technique

Optimizing Hole Shape and Improving Surface Quality of Inconel 718 Alloy by High-Temperature Chemical Assisted Laser Processing

A New Diamond Machining Approach for Extendable Fabrication of Micro-Freeform Lens Array

Micro-Fabrication and Monitoring of Three-Dimensional Microstructures Based on Laser-Induced Thermoplastic Formation

Scanning Tunneling Microscopy-Basedin Situmeasurement of Fast Tool Servo-Assisted Diamond Turning Micro-Structures

EDM Drilling Process of Micro Tapered Holes by Online Control of Machining Parameters

Scanning Tunneling Microscopy-Based in Situ Measurement of Fast Tool Servo-Assisted Diamond Turning Micro-Structures

An experimental study on a rapid micro imprinting process

Experimental investigation and optimization of modification during coaxial waterjet-assisted femtosecond laser drilling

A novel EDM method using longitudinal-torsional ultrasonic vibration (LTV) electrodes to improve machining performance for micro-holes

Research on hole depth in femtosecond laser deep micropore processing technology based on filament effect

Experimental Research on Deep-And-Narrow Micromilled Grooves Using a Self-Fabricated PCD Micro-Cutter

Mechanism design and process control of micro EDM for drilling spray holes of diesel injector nozzles

Micro-EDM Process for Micro Through-slit with Inside Sharp Edge