Abstract:In recent decades, the high catalytic activity of MgAl mixed oxides (MOs) and rehydrated hydrotalcites (HTCs) has made them very promising basic catalysts for various organic reactions. The synthesis procedure as well as the mechanism of the formation of HTC structure has been well described. Despite this, little has been published on how synthetic parameters affect the physico-chemical properties, rehydration ability and performance of the hydrotalcite-derived catalysts. Here, a series of catalysts with the same molar ratio Mg/Al = 3 varied by the co-precipitation conditions (pH value, temperature, ageing duration) were synthesized and used as precursors for the preparation of the MgAl MOs and rehydrated HTCs. The set of methods (AAS, XRD, SEM, N 2 -physisorption, TGA and CO 2 -TPD) was used to establish a relation between the synthetic parameters and the physico-chemical properties of the prepared materials. Their catalytic performance was monitored in aldol condensation of furfural and acetone as a model reaction. Preparations at different pH values and temperature resulted in the formation of HTC samples with crystallite size evaluated by XRD in the range of 70–230 Å ( d 003 ). Nevertheless, the crystallite size of the resulting MOs was similar in the range of 30–36 Å ( d 003 ). The rehydration of the MOs for 5–120 min produced high-crystalline reconstructed HTC with a crystalline size in the range of 82–111 Å ( d 003 ), i.e. the crystallite size of a large-size HTC precursor was not restored. Catalytic results revealed that the crystallite size of an as-prepared HTC precursor was a crucial parameter that affected the performance of both MOs and reconstructed HTCs in the condensation reaction. Furfural conversion over MOs and short-time rehydrated (5–10 min) materials in the reaction was strongly dependent on initial size of the as-prepared HTC crystallites. In contrast, the catalytic performance of the catalysts rehydrated for 120 min, was similar: furfural conversion was above 99% in all cases. Based on these results, the effect of the physico-chemical properties of the as-prepared HTCs on the catalytic performance of both MOs and reconstructed MgAl HTCs was established. A difference in the properties of the prepared samples was explained assuming the existence of extra-framework or partially framework Al-rich species that prevented the access of reactant molecules to catalytically active sites: the larger the crystallite size of the as-prepared precursor, the higher the excess of both structural defects and non-framework Al-rich species, and the lower the furfural conversion over these catalysts. Nevertheless, long rehydration time favored the involvement of the Al-rich species in the recrystallization of HTC structure as evidenced by SEM. As a consequence, furfural conversion increased over these catalysts. These results provide a new insight into the influence of synthetic parameters on the properties of MOs and rehydrated HTCs: the crystallite size of the as-prepared precursors determines the performance of the produced catalysts in aldol condensation by affecting the rehydration ability of the derived MOs.

Environmentally benign synthesis of hydrotalcite-like materials for enhanced efficiency of aldol condensation reactions

On the influence of synthetic parameters on the properties and aldol condensation performance of the MgAl mixed oxides and rehydrated hydrotalcites

Ce/MgAl mixed oxides derived from hydrotalcite LDH precursors as highly efficient catalysts for ketonization of carboxylic acid

Preparation of PtCl62-Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Preparation of PtCl_6~(2-) Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Facile One-Pot Synthesis of Functional Hydrochar Catalyst for Biomass Valorization

Catalytic Transfer Hydrogenation Of Oleic Acid To Octadecanol Over Magnetic Recoverable Cobalt Catalysts

Effect of coprecipitation method on Mg–Al hydrotalcite properties: application in the synthesis of diethylene glycol di-(methyl carbonate)

Cu/MgAl(2)O(4) as bifunctional catalyst for aldol condensation of 5-hydroxymethylfurfural and selective transfer hydrogenation

The Function of Hydrotalcite as a Support Material in the Alcohol-Assisted Catalytic CO2 Hydrogenation Reaction

Highly Efficient Procedure for the Synthesis of Schiff Bases Using Hydrotalcite‐like Materials As Catalyst

Elucidating the Crystal Face- and Hydration-Dependent Catalytic Activity of Hydrotalcites in Biodiesel Production

Geometric effect promoted hydrotalcites catalysts towards aldol condensation reaction

In Situ Growth of Tungsten Oxide on Alumina to Boost the Catalytic Performance of Platinum for Glycerol Hydrogenolysis

Efficient synthesis of Co 2+ –Co 3+ hydrotalcite-like compounds via NaOH precipitation in methanol–water under mild alkaline conditions

Synthesis Of Mg-Zn-Al Hydrotalcites-Like And Catalytic Activities Of Their Composite Oxides

Synthesis Of Sulphur-Modified Bifunctional Hydrotalcites And Study Of Their Surface Characteristics By Inverse Gas Chromatography

Effect of interlayer anions on the catalytic activity of Mg-Al layered double hydroxides for furfural and acetone aldol condensation reaction

Synthesis, Characterization And Isopropanol Catalytic Reaction Of Mg/Al,Co/Al And Co/Mg/Al Mixed Oxides From Hydrotalcite And Hydrotalcite-Like Precursors

Synthesis of hollow HZSM-5 zeolite-based catalysts and catalytic performance in MTA reaction

M−Mn−Al Hydrotalcite-like Compounds As Precursors for Methyl Benzoate Hydrogenation Catalysts