Abstract:In general, the method proposed by Whitfield and Baines is adopted for the turbine preliminary design. In this design procedure for the turbine blade trailing edge geometry, two assumptions (ideal gas and zero discharge swirl) and two experience values (W-R and gamma) are used to get the three blade trailing edge geometric parameters: relative exit flow angle beta(6), the exit tip radius R-6t and hub radius R-6h for the purpose of maximizing the rotor total-to-static isentropic efficiency. The method above is established based on the experience and results of testing using air as working fluid, so it does not provide a mathematical optimal solution to instruct the optimization of geometry parameters and consider the real gas effects of the organic, working fluid which must be taken into consideration for the ORC turbine design procedure. In this paper, a new preliminary design and optimization method is established for the purpose of reducing the exit kinetic energy loss to improve the turbine efficiency eta(ts), and the blade trailing edge geometric parameters for a small scale ORC turbine with working fluid R123 are optimized based on this method. The mathematical optimal solution to minimize the exit kinetic energy is deduced, which can be used to design and optimize the exit shroud/hub radius and exit blade angle. And then, the influence of blade trailing edge geometric parameters on turbine efficiency eta(ts) are analysed and the optimal working ranges of these parameters for the equations are recommended in consideration of working fluid R123. This method is used to modify an existing ORC turbine exit kinetic energy loss from 11.7% to 7%, which indicates the effectiveness of the method. However, the internal passage loss increases from 7.9% to 9.4%, so the only way to consider the influence of geometric parameters on internal passage loss is to give the empirical ranges of these parameters, such as the recommended ranges that the value of gamma is at 0.3 to 0.4, and the value of tau is at 0.5 to 0.6.

Optimal design of radial inflow turbine for ocean thermal energy conversion based on the installation angle of nozzle blade

Thermodynamic performance of a radial-inflow turbine for ocean thermal energy conversion using ammonia

Study on the Performance of a 300W Counter-Rotating Type Horizontal Axis Tidal Turbine

Structural Design and Analysis of a 100 kW Radial Turbine for an Ocean Thermal Energy Conversion–Organic Rankine Cycle Power Plant

Performance Study of Energy Conversion System for Ocean Thermal Profiler

Identification of nonparametric thermodynamic model and optimization of ocean thermal energy conversion radial inflow turbine

Numerical and Experimental Study of the Ocean Thermal Energy Capture Process Utilizing Metal Foam–phase-Change Material (PCM) Composites

Experimental Research of an Ocean Thermal Engine with Phase-Change Material

Auxiliary Heat System Design and Off-Design Performance Optimization of OTEC Radial Inflow Turbine

Experimental study of a miniature organic Rankine cycle unit using ocean thermal energy

Numerical Analysis of the Influence of Design Parameters on the Efficiency of an OWC Axial Impulse Turbine for Wave Energy Conversion

Design and Experimental Study of 50 kW Ocean Thermal Energy Conversion Test Platform Based on Organic Rankine Cycle

Optimal design of horizontal axis tidal current turbine blade

Study on the Effects of Blades Outer Angle on the Performance of Inline Cross-Flow Turbines

Optimization of the Blade Trailing Edge Geometric Parameters for A Small Scale Orc Turbine

Investigations on ORC Radial Inflow Turbine Three-Dimensional Geometry Design and Off-Design Performance Prediction

Research on the Energy Capture Device of Horizontal Axis Tidal Current Energy Conversion Systems

Effect of working fluid on the ORC cycle performance of the ocean thermal energy conversion system

Experimental Research and Improved Neural Network Optimization Based on the Ocean Thermal Energy Conversion Experimental Platform

A Novel Analysis Framework for the Organic Rankine Cycle Waste Heat Recovery System: from the Viewpoint of Turbine Design

Investigation of the Organic Rankine Cycle (ORC) System and the Radial-Inflow Turbine Design