Abstract:Abstract The discovery of the fiber Bragg grating (FBG) is an early milestone in developing optical fiber technology, such as optical communication to monitoring material health structures as sensors. For optical communication, the FBG components are capable of filtering functions. As a sensor, it has a high sensitivity immune to electromagnetic wave interference, is small in size, and is resistant to extreme environmental conditions. The sensitivity of the FBG sensor is obtained from the shift in the peak wavelength of each of the temperature and strain quantities. However, the performance of the FBG sensor can be improved by engineering the distribution of the refractive index on the grid with the apodization and chirp functions. Apodization is a technique to improve the performance of the FBG to eliminate noise, narrow the full width half maximum, lower the side lobes of the main lobe, and improve the spectrum ripple factor. Apart from apodization, the chirp function also affects the sensor sensitivity and the refractive index distribution on the grid. Numerical experiments were carried out in designing the FBG component as a sensor using Gaussian apodization and Topas (cyclic olefin copolymer) for several chirp functions. The results show that the Gaussian apodization Topas for all chirp functions as a strain sensor has the same sensitivity, namely 0.84 pm/μstrain while for temperature sensors with the highest sensitivity is obtained at cubic root chirp of 13.82857 pm/°C followed by square root chirp of 13.74286 pm/°C, quadratic chirp 13.71429 pm/°C, and linear chirp 13.4 pm/°C. The Bragg wavelength shift was greater for 1 °C than for the 1 μstrain.

Temperature sensing of π-PSFBG with ITO film coated by PLD method

Modeling and analysis of localized biosensing and index sensing by introducing effective phase shift in microfiber Bragg grating (μFBG)

Modulation of the Dual Resonant Peaks of a Long-Period Fiber Grating Towards Highly Sensitive Sensing by Means of Polymeric Nanocoatings for Biosensing Applications

Sensitivity-enhanced temperature sensor based on PDMS-coated long period fiber grating

Long-Period Fiber Grating Sensor Based on a Conductive Polymer Functional Layer

Parallel-Integrated Fiber Bragg Gratings Inscribed by Femtosecond Laser Point-by-Point Technology

Study of Sensing Properties and Contrastive Analysis of Metal Coating Optical Fiber Grating

LONG-PERIOD FIBER GRATING COATED WITH PNIPAM FOR THERMAL SENSING APPLICATIONS

A Cheap and Practical FBG Temperature Sensor Utilizing a Long-Period Grating in a Photonic Crystal Fiber

Sensing Characteristics of Tilted Long Period Fiber Gratings Inscribed by Infrared Femtosecond Laser

The Improvement of Temperature Sensitivity by Eliminating the Thermal Stress at the Interface of Fiber Bragg Gratings

Temperature Sensing of Metal-Coated Fiber Bragg Grating

An Electroplating Method for Surface Mounting Optical Fiber Sensors on the Metal Substrate

Integration of chirping and apodization of Topas materials for improving the performance of fiber Bragg grating sensors

Review of Femtosecond-Laser-Inscribed Fiber Bragg Gratings: Fabrication Technologies and Sensing Applications

Fiber Bragg grating sensing system for temperature measurements based on optically injected DFB-LD with an OEO loop

Strain and Temperature Discrimination by Using Temperature-Independent FPI and FBG

High-Spatial-Resolution High-Temperature Sensor Based on Ultra-Short Fiber Bragg Gratings With Dual-Wavelength Differential Detection

Direct Bragg Grating Inscription in Single Mode Step-Index TOPAS/ZEONEX Polymer Optical Fiber Using 520 nm Femtosecond Pulses