Abstract:Planar steel plates have many advantages, including high precision, flexible outline shape fabrication, and convenient transportation and storage, which make them suitable for various steel structures (e.g., reticulated shell structures). However, the steel plates are not commonly used as structural members, because they have a relatively low out-of-plane flexural stiffness. To improve the flexural buckling resistance, a novel type of built-up plate member comprising two longitudinal plates is proposed in this study. Additionally, the flexural buckling behavior of the novel built-up members is investigated. A series of compression tests on 42 specimens of built-up plate members is conducted to determine the elastic and ultimate critical loads. Flexural buckling about the minor axis is observed to be the failure mode of the specimens. The equivalent slenderness ratio method is used to determine the theoretical elastic critical loads of the specimens. With consideration of the measured material properties, geometric imperfections, and residual stresses of the specimens, a refined finite-element model is developed to simulate the flexural buckling behavior. Furthermore, the applicability of two representative specifications (American and European) to the novel built-up member is discussed. The results indicate that the design strengths calculated using these specifications are generally conservative for determining the ultimate loads of the built-up plate members. Design curve “c” in Eurocode 3 is found to be the most suitable among the specifications of interest for determining the design strength. This study provides valuable guidance for the design of built-up plate members.

Experimental and numerical analysis of ultimate compressive strength of stiffened panel with openings

Experimental and numerical analysis of ultimate compressive strength of long-span stiffened panels

Ultimate uniaxial compressive strength of stiffened panel with opening under lateral pressure

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Experimental and numerical investigation on the ultimate strength of a ship hull girder model with deck openings

An experimental and numerical investigation on ultimate strength of stiffened plates with opening and perforation corrosion

A study of ultimate strengths of typical longitudinal girders with openings in container ships

Ultimate Strength of Simply Supported Plate with Opening under Uniaxial Compression

The Dynamic Ultimate Strength of Stiffened Panels under Axial Impact Loading

Study on the influence of localised thermal load on collapse strength of stiffened panels under longitudinal compression

Elastic Buckling of Stiffened Panels in Ships under Bi-Axial Compression

Formulation of Reduction Rate for Ultimate Compressive Strength of Stiffened Panel Induced by Opening

Ultimate Strength of Typical Stiffened Panels in Container Ships with Comparison of Hull Girder Bending Analysis

Ultimate strength analysis of composite laminated ship panels

Empirical formulae assessment of ultimate strength for perforated stiffened panels under longitudinal compression

Progressive collapse analysis and ultimate strength estimation of continuous stiffened panel under longitudinal extreme cyclic load and lateral pressure

Dynamic Ultimate Strength of Outer Bottom Stiffened Plates under In-Plane Compression and Lateral Pressure

Ultimate strength of stiffened panels with a crack and pits under uni-axial longitudinal compression

Ultimate Strength of Container Ship Bilge Panels Subjected to Axial Compression Combined with Bending and Lateral Pressure

Experiment Study of Critical Dynamic Loads for Stiffened Panels under Axial Impact

Experimental and Numerical Study on the Ultimate Strength of Stiffened Plates Subjected to Combined Biaxial Compression and Lateral Loads