In-situ electrokinetic remediation of salt-impacted soil at a decommissioned well site

Kong, Ricky S.

DOI: https://doi.org/10.1007/s10800-023-02046-z

IF: 2.925

2024-01-26

Journal of Applied Electrochemistry

Abstract:Chemical spills are common at oil and gas facilities and traditionally remediation occurs by excavating and removing the contaminated soil, which is environmentally destructive and financially expensive. Electrokinetic (EK) remediation is an alternative method that can reduce the amount of soil that is removed and relies on the electromigration of ions towards the electrodes after a current is applied. We investigated whether EK remediation would affect soil electrical conductivity (EC), Na + , K + , Mg 2+ , Ca 2+ , Cl – , and SO 4 2– concentrations at various soil depths. The study occurred at a decommissioned oil wellsite in northern Alberta, where processed water spills had occurred. The treatments included (1) one EK run + 100 kW power [Zones E and G], (2) one EK run + 300 kW power [Zones B and H], (3) two EK runs + 100 kW power [Zones C and F]. The treatments reduced EC within the top 2 m of the soil, which was associated with reductions in Na + and Cl – in Zones BH and EG, and reductions in Mg 2+ in Zones CF. Sulfates were elevated in the top 2 m in all treatments relative to the control. Higher EC values were observed in Zones BH (300 kW) relative to Zones EG (100 kW) at all depths. In addition, Zones CF (2 EK cycles) had higher EC than Zones EG (1 EK cycle). When initial concentrations are considered, increased power and duration may improve efficacy. EK technology can be a tool to remediate sites and potentially reduce the impacts on the environment.

electrochemistry