Enhanced Electromechanical Properties of Nitrile Rubber Dielectric Elastomer Composites by SrTiO3‐PPy‐PCPA Multilayer Core‐Shell Hybrids Construction

Xiaowei Liu,Mengnan Ruan,Bo Li,Weixue Cao,Yuxin Sun,Ke Ruan,Zhifeng Liu

DOI: https://doi.org/10.1002/slct.202402217

2024-10-24

ChemistrySelect

Abstract:In this work, high performance NBR dielectric elastomer composites are obtained by synthesising the core‐shell structure STO‐PPy‐PCPA and the actuated strain is enhanced from 3.28 % (pure NBR) to 13.86 (5 phr STO‐PPy‐PCPA/NBR). In order to obtain high dielectric properties nitrile rubber (NBR) dielectric elastomer composites, in this work, polypyrrole (PPy) was encapsulated on the surface of SrTiO3 (STO) ceramic particles, and an insulating layer of poly (catechol/polyamine) (PCPA) was also covered on the outer surface of the STO‐PPy core‐shell particles (denoted as STO‐PPy‐PCPA particles), then the dielectric elastomer composites were prepared by adding STO and STO‐PPy‐PCPA to NBR, respectively. Due to the electrical conductivity of PPy, the dielectric constant of the STO‐PPy‐PCPA particles increases substantially. At the same time, the insulating layer of PCPA further prevents current leakage from the composite, which not only avoids premature electrical breakdown but also effectively reduces the dielectric loss. Compared with pure NBR, the dielectric constant of the prepared dielectric elastomer composites increased from 13 to 17.19 (20 phr STO‐PPy‐PCPA/NBR), and the actuated strain increased from 3.28 % to 13.86 % (5 phr STO‐PPy‐PCPA/NBR), which is 4.2 times that of pure NBR. This work successfully solves the current problems of requiring a large amount of ceramics to improve the dielectric constant and the tendency of conductive particles to agglomerate and premature breakdown.

chemistry, multidisciplinary