Effect of Minimum Quantity of Lubricant on Carbide Tools and Surface Integrity in the Machining of Titanium Aluminides

Enrique García-Martínez,Valentín Miguel,Alberto Martínez-Martínez

DOI: https://doi.org/10.3390/met14040399

IF: 2.695

2024-03-29

Metals

Abstract:Titanium aluminides are being explored as potential materials for the aeronautical sector. However, their application is limited by the high costs of processing and their difficulties in machining. This research evaluates the effectiveness of the minimum quantity lubrication technique (MQL) on the turning process of Ti48Al2Cr2Nb aluminide in terms of tool wear, tool life, cutting forces, surface integrity, and temperature. It was found that MQL conditions can improve the process efficiency, reducing the thermally induced wear mechanisms and enlarging the tool life compared to dry machining. Furthermore, it allows the cutting speed to be incremented, leading to lower processing times. However, MQL seems to not be effective in the reduction of the strain-hardening effect near the machined surface and, although the number of microcracks is reduced, defect-free surfaces cannot be obtained. Moreover, similar microstructural alterations as for dry cutting were detected. The best cutting conditions in terms of surface quality were assessed using the central composite face (CCF) design and surface response methodology. Optimization of the surface roughness under industrially viable cutting conditions was achieved with an average surface roughness value, Ra, of 0.29 μm (feed rate of 0.05 mm/rev, a cutting speed of 54.6 m/min and a depth of cut of 0.125 mm).

materials science, multidisciplinary,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

This paper attempts to solve the problems encountered in the machining process of titanium - aluminum alloy (Ti48Al2Cr2Nb), especially how to improve tool wear, extend tool life, reduce cutting force, improve surface integrity and lower temperature through Minimum Quantity Lubrication (MQL) technology. Specifically:

1. **Tool Wear and Life**:
- The research evaluated the influence of MQL technology on tool wear and found that MQL can significantly reduce the tool wear rate, thus extending the tool life. Especially at higher cutting speeds, the effect of MQL is more obvious.

2. **Cutting Force**:
- Through experiments, the research found that the growth rate of cutting force under MQL conditions is smaller than that of dry cutting, especially the radial cutting force. This indicates that MQL helps to reduce friction during the cutting process, thereby reducing the cutting force.

3. **Temperature**:
- Although MQL is not directly used to reduce temperature, the research found that MQL can reduce friction, thereby reducing the cutting temperature by about 100 °C. At higher cutting speeds, the temperature under MQL conditions is always lower than that of dry cutting.

4. **Surface Integrity**:
- The research evaluated the improvement effect of MQL on surface integrity. Although MQL cannot completely eliminate micro - cracks, it can significantly reduce the density of micro - cracks. In addition, the surface quality obtained under MQL conditions is better than that of dry cutting.

5. **Sub - surface Hardening and Micro - structural Changes**:
- The research also analyzed the influence of cutting speed on sub - surface hardening and micro - structural changes under MQL conditions. The results show that MQL has little influence on the degree of sub - surface hardening, but can reduce the generation of micro - cracks.

In general, this paper aims to optimize the cutting process of titanium - aluminum alloy through MQL technology, improve processing efficiency and surface quality, and at the same time reduce environmental impacts.