Manipulating Electrical Properties of Silica-Based Materials via Atomic Oxygen Irradiation

Ning Luo,Yange Feng,Xiaojuan Li,Weixiang Sun,Daoai Wang,Qian Ye,Xiaojun Sun,Feng Zhou,Weimin Liu
DOI: https://doi.org/10.1021/acsami.1c02259
2021-03-24
Abstract:Regulated triboelectrification has attracted considerable research attention due to its potential applications in harvesting energy and importance in antistatic protection. Irradiation is an effective and stable modification method due to its adjustable and uniform irradiation parameters. Moreover, atomic oxygen (AO) irradiation is an important component in the low earth orbit, which is a considerable factor for promoting triboelectric nanogenerators (TENGs) in the outer space. AO irradiation was utilized to manipulate the surface structure and chemical composition to regulate electrical properties. AO irradiation can increase electron-donating groups and enhance electrical positivity of polydimethylsiloxane (PDMS) films due to the transition from Si–C bonds to Si–O bonds. Therefore, different trends of polytetrafluoroethylene (PTFE) and polystyrene (PS) were caused by their TENG composition with irradiated PDMS. Tribocharge cross-over polarity and charge generation were prevented completely in PS- and PDMS-based TENGs by adjusting the irradiation time to 4.1 h. Short-circuit current enhanced from 5 to 22 μA and the output voltage increased from 160 to 760 V when PDMS films in PTFE- and PDMS-based TENGs were subjected to AO irradiation for 6 h. This study demonstrated that AO irradiation can manipulate triboelectric properties of silica-based materials, which are potential components for harvesting energy and preventing electrostatic hazard in the outer space.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c02259?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c02259</a>.Comparison of antistatic effects between the pristine and irradiated 4.1 h PDMS films (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c02259/suppl_file/am1c02259_si_001.mp4">MP4</a>),360 commercial LEDs was lighted up by TENGs based on the pristine and irradiated PDMS films separately (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c02259/suppl_file/am1c02259_si_002.mp4">MP4</a>),SEM and EDS of the PDMS films with and without AO irradiation, relationship between AO irradiation time and the water contact angle on the PDMS films, long-time resistance of the AO irradiated TENG, short-circuit current of Cu, PTFE and PS films in contact with Nylon films under different irradiation times from 0 to 8 h, illustration of the influence of AO irradiation on the packaged TENGs and the optical photograph of the packaged device with and without aluminum foil, variation of short-circuit current of the packaged TENGs based on PDMS and Nylon films with 8 h AO irradiation, short-circuit current of silicone rubber and PTFE based TENGs under different irradiation times from 0 to 7 h, and comparison of AO irradiation with other works in manipulating electrical properties of TENGs (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c02259/suppl_file/am1c02259_si_003.pdf">PDF</a>)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology
What problem does this paper attempt to address?