Abstract:Recently, many studies have reported the ultralow friction coefficient of sliding friction between rigid solid surfaces in aqueous lubrication. A running-in process that goes through high-friction and friction-decreasing regions to a stable ultralow friction region is often required. However, the role of the friction-decreasing region is often ascribed to tribofilm formation in which complexity hindered the quantitative description of the running-in process and the prediction of its subsequent lubrication state. In this work, the frictional energy ( Ef) dissipated in the running-in process of a poly(oligo(ethylene glycol) methyl ether acrylate) aqueous lubrication was related to the wear of solid surfaces under different conditions and lubrication states. Experimental results indicated that the high-friction region was in a boundary lubrication state, contributed to most of the wear, and significantly reduced the contact pressure, whereas the friction-decreasing region was in a mixed lubrication state, contributed only to the slight and slow removal of materials, and slightly reduced the contact pressure. Therefore, by establishing relationships among the wear scar diameter, Ef, and the Stribeck curve of the tribological system, the subsequent lubrication state after a running-in process under various working loads and sliding speeds could be quantitatively predicted. The running-in experiments with different aqueous lubrication systems showed good agreement with the prediction of this method. This investigation provides an effective method for the wear and lubrication state prediction after a running-in process, further proving the importance of the Stribeck curve for a lubrication system. This study may also have important implications for the strategy design of the running-in process in various industrial applications.

Characterization of the friction-induced attractor trajectories during the running-in process in ball-on-disk tribosystem

Differential Model of Friction Based on Bristle Model and Phase-Transition Theory

Chaotic characteristics and attractor evolution of friction noise during friction process

Correlation Between Friction Coefficient and Friction Vibration in Running-In Process Based on Cross Recurrence Plots

Dimensional Discussion of Traction Force Vector on Ball/Raceway Interface and Study of Bearing Dynamic Behavior

Wear Characterization under Sliding–rolling Contact Using Friction-Induced Vibration Features

In-situ Characterization of Three Dimensional Worn Surface under Sliding-Rolling Contact

Dynamic Identification of Tangential Contact Stiffness by Using Friction Damping in Moving Contact

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Topography Characterization of Friction Pairs During the Real-Time Wear Process in Dry Condition

Friction and Wear On-Line Monitoring and Wear Mechanism Analysis under Dynamic Loading Manners

Estimation of Rolling Friction Coefficients in a Tribosystem Using Optical Measurements

Analytical modeling method for joint friction in harmonic drive robot

On Lubrication States after a Running-In Process in Aqueous Lubrication.

Traction Behaviours of Aviation Lubricating Oil and the Effects on the Dynamic and Thermal Characteristics of High-Speed Ball Bearings

Investigation of Interfacial Friction and Inverse Flowing Behavior under the Adhesive State

Traction Effects on the Dynamics of Ball Bearings

Transient-mixed lubrication model numerically for friction and wear of journal bearings under heavy load during start-up

Experimental Investigation on the Friction-Induced Vibration with Periodic Characteristics in a Running-In Process under Lubrication

Study on the Frictional Performance of Slide and Plateau Honed Cylinder Liners During Running-in

A Study of Tribological Performance Prediction Based on Surface Texture Parameters