Abstract:Accessories such as joints and terminations represent weak points in HVDC cable systems. The DC field distribution is intimately dependent on the thermal conditions of the accessory and on material properties. Moreover, there is no available method to probe charge distribution in these conditions. In this work, the field distribution in non-stationary conditions, both thermally and electrically, is computed considering crosslinked polyethylene (XLPE) as cable insulation and different insulating materials (silicone, rubber, XLPE) for a 200 kV joint assembled in a same geometry. In the conditions used, i.e., temperatures up to 70 °C, and with the material properties considered, the dielectric time constant appears of the same order or longer than the thermal one and is of several hours. This indicates that both physical phenomena need to be considered for modelling the electric field distribution. Both the radial and the tangential field distributions are analysed, and focus is given on the field distribution under the stress cone on the ground side and near the central deflector on the high voltage side of the joint. We show that the position of the maximum field varies in time in a way that is not easy to anticipate. Under the cone, the smallest tangential field is obtained with the joint insulating material having the highest electrical conductivity. This results from a shift of the field towards the cable insulation in which the geometrical features produce a weaker axial component of the field. At the level of the central deflector, it is clear that the tangential field is higher when the mismatch between the conductivity of the two insulations is larger. In addition, the field grows as a function of time under stress. This work shows the need of precise data on materials conductivity and the need of probing field distribution in 3D.

Exploration of Temperature Inversion in Intermediate Joints of 10 kV Three-Core Cable

Real‐time Calculation of Three Core Cable Conductor Temperature Based on Thermal Circuit Model with Thermal Resistance Correction

Research on Temperature Sensing Method for Three-Core Cable Intermediate Joint Considering Three-Phase Load Imbalance

Temperature Field Calculation and Thermal Circuit Equivalent Analysis of 110 kV Core Cable Joint

Study on Temperature Cascade ELM Inversion Method for 110 kV Single-Core Cable Intermediate Joints

Study on the temperature distribution of the outer surface of the cable intermediate joint based on ANSYS simulation

DC Electric Field Optimization of AC XLPE Cable Joint in DC Operation

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

3-D thermal analysis and contact resistance evaluation of power cable joint

Coupled Thermal-Electrical Analysis of 110 Kv Corrugated Aluminum Sheathed and Smooth Aluminum Sheath Cables Based on Finite Element Simulation Method

Experimental Study on Cable Joint Temperature Measurement Technology Under Step Current

Strongly robust approach for temperature monitoring of power cable joint

Inversion of Soil Thermal Conductivity and Ampacity of the Buried High Voltage Power Cables

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

An Improved Analytical Thermal Rating Method for Cable Joints

Numerical analysis of thermo-electric field for 10 kV AC XLPE cable in DC operation

Electric field calculation and optimization for stress cone of DC cable joint based on the coaxial double-layer insulation model

Temperature field simulation of medium and low voltage composite cable

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Numerical Analysis of Thermo-Electric Field for AC XLPE Cable in DC Operation Based on Conduction Current Measurement.

Electric Field Distribution in HVDC Cable Joint in Non-Stationary Conditions